Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Highland Highland Tec/Rec Harness
- Page 1 Installing the Highland Tec/Rec Harness on the Highland Backplate...
- Page 2 Harness Contents Install shoulder D-rings. Using a 3-bar slide, install a D-ring on - 12 ft. (3.7 m) Harness Webbing each shoulder approximately with Center Grommet 10–12 in. (25–30 cm) down from - 1 ea. Crotch Strap with the plate (Fig. 3). Final position- SS Adjuster (HL810) ing of the hardware occurs at the - 1 ea.
- Page 3 Install waist D-rings. Using a bridge and out the narrow slot. 3-bar slide, install a D-ring, facing Pass the webbing through the outward on each hip. This would lower 2 in. (5 cm) slot, from back be roughly 8-10 in. (20-25 cm) of plate to front of plate.
- Page 4 www.highlandscuba.com RM0285 rev 18A...
Need help?
Do you have a question about the Highland Tec/Rec Harness and is the answer not in the manual?
Questions and answers