Advertisement
HEAT CALIBRATION
The sensors of MT 150 SET Room Controls are very sensitive in comparison to domestic
thermometers. If you would like to refer to your domestic thermometer, please calibrate your room
control.
-
When the unit is off, please press "
•
Please adjust temprature difference by using + and – buttons in order to calibrate the device.
This value can be set between -8 and +8.
•
Press "
" 4 times to exit the menu
Warning: Recommended heat calibration value is "
IN TRODUCTION OF ROOM CONTROL TO THE RECEIVER
Each room control is defined with its own receiver. In case of a loss of signal, you can make an
introduction by following the below steps. Do not attempt this unless needed.
-
Open the cover on the receiver.
•
After energy is provided to the receiver, press IP_SET button on the receiver.
•
When wireless room control is in OFF position, press
heat calibration settings will appear. If
control will appear.
•
Next, press "+" or "-". The flashing green led on the receiver will be constant and there will
be a warning sound from the receiver.
•
Now the room control and the receiver are introduced to each other.
•
Press "
" 4 times to exit the menu
DIMENSIONS
Thermostat dimension : 80 mm×80 mm×25 mm
Receiver dimension. 86 mm × 86 mm × 23 mm
" for 3 seconds.
button for 3 seconds. The menu for
is pressed again, the serial number of room
Advertisement
