SPC Thermatile Ten-Twelve Installation Instructions Manual

Radiant panels

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Thermatile Ten-Twelve

Radiant Panels

Installation instructions

Table of Contents

Need help?

Do you have a question about the Thermatile Ten-Twelve and is the answer not in the manual?

Questions and answers

Summary of Contents for SPC Thermatile Ten-Twelve

Page 1 Thermatile Ten-Twelve Radiant Panels Installation instructions...
Page 2: Table Of Contents
IOM 53, Issue 13 - Thermatile TEN-TWELVE Contents Page General Description Receipt and Preparation Storage and Handling Dimensional Data Technical Data Installation Ceiling Grid Free Hanging Plasterboard Multiple Panels Wire/Rod Hanging Requirements Non-standard Applications Electrical Connections Mounting Height Operation Cooling Applications...
Page 3: General
IOM 53, Issue 13 - Thermatile TEN-TWELVE 1. General 1.1 Description The SPC Thermatile TEN-TWELVE panels are Panels can also be supplied with special brackets manufactured from a unique aluminium sandwich for wall rather than ceiling mounting. Free hanging panel that is both structurally rigid and an panels would normally be supplied without excellent conductor of heat.
Page 4: Storage And Handling
IOM 53, Issue 13 - Thermatile TEN-TWELVE 1.3 Storage and Handling Panels are packed in cardboard cartons and report any damage or missing parts to the bearing the SPC works order number, model carrier and SPC immediately. reference and site references where appropriate.
Page 5: Installation
IOM 53, Issue 13 - Thermatile TEN-TWELVE 2. Installation 2.1 Ceiling Grid Single panels are typically placed into a T-bar Panels may be supplied with connecting hoses type ceiling grid based on a 600mm square grid which will be either 15mm or 22mm and either pattern.
Page 6: Plasterboard
IOM 53, Issue 13 - Thermatile TEN-TWELVE 2.3 Plasterboard Panels are available for plasterboard ceilings and order to properly mount plasterboard panels; the are supplied with a special frame. The frame is an primary support is via the hanging wires and the...
Page 7: Multiple Panels
IOM 53, Issue 13 - Thermatile TEN-TWELVE SECTION VIEW Wooden Batten Plaster Board Thermatile Frame Figure 1. Plasterboard hanging 2.4 Multiple Panels When panels are intended for installation in The longer hoses are for connection to the main continuous runs they may be supplied with flow and return piping.
Page 8: Wire/Rod Hanging Requirements
IOM 53, Issue 13 - Thermatile TEN-TWELVE 2.5 Wire/Rod Hanging Requirements The panels are supplied as standard with the not designed to be suitable for significant lateral necessary quantity of fixing brackets fastened to forces. the rear of the panel. The standard bracket suits...
Page 9: Non-Standard Applications
IOM 53, Issue 13 - Thermatile TEN-TWELVE 2.6 Non-standard Applications Panels may be supplied for other than ceiling necessary support struts and hanging brackets. mounting. Panels can be fitted vertically to walls Such installations are normally bespoke and fitting or at an angle from the wall at high level. In this...
Page 10: Mounting Height
IOM 53, Issue 13 - Thermatile TEN-TWELVE 2.8 Mounting height The chart showing minimum mounting heights of asymmetric radiation. The chart is for static recommends the minimum height that the occupancy; if occupants are moving around the panels should be mounted at, from the ground,...
Page 11: Operation
IOM 53, Issue 13 - Thermatile TEN-TWELVE 3. Operation Ensure that the panels are piped together and Zone valves should open and close in response into the heating (cooling) system as required to the sensed room or zone temperature and by the application.
Page 12: Appendix
IOM 53, Issue 13 - Thermatile TEN-TWELVE 5. Appendix 5.1 Appendix 1 - Wall-mounted installation Below are examples of typical wall-mounted When installing wall mounted panels it is applications where the panels are mounted at important that all the brackets and pivot arms an angle from the wall.
Page 13 IOM 53, Issue 13 - Thermatile TEN-TWELVE Top Edging Fits Under Ball Guard Long Edging Loosley Secure End Cap Clips To End Through Hole In Ball Of Radiant Panel Guard With Tie Wraps Provided Figure A2.
Page 14: Appendix 2 - Plastic Ball Guard
IOM 53, Issue 13 - Thermatile TEN-TWELVE 5.2 Appendix 2 - Plastic ball guard If panels are to be suspended at high level in point of overlap as shown. Intermediate brackets sports halls they may be supplied with rigid plastic...
Page 15: Appendix 3 - Site Handling
IOM 53, Issue 13 - Thermatile TEN-TWELVE 5.3 Appendix 3 – Site Handling The radiant panels are likely to have been supplied If unpackaged panels are stacked they must be with steel hanging brackets. When packed these stacked as shown in the packaging label below...
Page 16: Appendix 4 - Bracket Positions
IOM 53, Issue 13 - Thermatile TEN-TWELVE 5.4 Bracket Positions TEN - Stand Alone Cartridge Panel 41.6 TYP DIM "A" "B" PITCHES OF "C" DIM "A" "LENGTH" Nominal Hanging Length DIM A DIM B DIM C Length Points PICTORIAL ISO VIEW...
Page 17 IOM 53, Issue 13 - Thermatile TEN-TWELVE TWELVE - Middle Section Cartridge Panel 36.6 TYP DIM "A" "B" PITCHES OF "C" DIM "A" "LENGTH" Nominal Hanging Length DIM A DIM B DIM C Length Points 1800 1790 2400 2390 3000...
Page 18 IOM 53, Issue 13 - Thermatile TEN-TWELVE TWELVE - Middle Section Cartridge Panel = T-Bar 36.6 TYP "B" PITCHES OF "C" DIM "A" DIM "A" "LENGTH" Nominal Hanging Length DIM A DIM B DIM C Length Points 1800 1790 2400...
Page 19 IOM 53, Issue 13 - Thermatile TEN-TWELVE TWELVE - Cartridge Panel In Runs = Plasterboard "PANEL LENGTH" "PANEL LENGTH" DIM "A" "B" PITCHES OF "C" "B" PITCHES OF "C" DIM "A" HOLE CENTRES "D" PITCHES OF "E" "D" PITCHES OF "E"...
Page 20 SPC House Evington Valley Road Leicester LE5 5LU T: 0116 249 0044 E: spc@spc-hvac.co.uk spc-hvac.co.uk IOM 53, Issue 13 - Thermatile TEN-TWELVE...