Charging The Shaver - Braun InterFace 3612 User Manual

1 Description
1 Foil protection cap
2 Shaving frame
2a Shaving foil
2b Floating cutter
3 Cutter block

2 Charging the shaver

• For the 3 first chargings: Plug the shaver into an electrical outlet and charge
it for at least 4 hours (switch position «off»).
The charging light (7) illuminates when the shaver is in charging mode.
Then shave without the cord until it runs distinctly slower.
• Subsequent charges will take approximately 1 hour.
The full capacity is reached after several charge/discharge cycles.
A full charge will give you approximately 30 min shaving capacity.
• Wattage: 4 Watts
Voltage range during charging: 12-240 V2/ 50 or 60 Hz (automatic adaptation)
Best environmental temperature range for charging: 60 °F to 95 °F /
15 °C to 35 °C
3 Shaving
3.1 Switch positions
off = Switch is locked.
To activate it, press the red button and push the switch up:
on = Combination shave (simultaneous use of floating cutter and
shaving foil). The floating cutter cuts longer beard hairs or curly
«problem hairs», the foil follows to give a close, smooth shave (b).
foil = Shaving foil without floating cutter.
trim = The long hair trimmer is activated (for trimming sideburns, moustache
and beard) (c).
3.2 Shaving with the cord
If the cell unit is discharged, you may also shave with the shaver connected to
an electrical outlet (100 -240 V 2). (If the shaver should not run immediately,
charge it with the switch on position «off» for approx. 1 minute.)
Tips for the perfect shave
• We recommend that you shave before washing, as the skin tends to be
slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction of beard growth.
• Replace the shaving foil and cutter block every 1
are worn, to ensure optimum shaving performance.
6
4 Release button
5 Pop-out long hair trimmer
6 Switch
7 Charging light
8 Shaver socket
1
/
2
years, or when the parts