Advertisement
5. Maintenance
5.1.
The lifetime of a filter depends on many factors including the work rate, the airflow and the concentration of the contaminant in the
atmosphere. A gas filter should be changed immediately when chemical breakthrough of a contaminant is detected by smell, taste
or any other means. A dust filter should be changed when breathing becomes impaired. The exterior of the filter can be cleaned
with the use of a damp cloth. Solvents must not be used and care should be taken to ensure no water enters the filter. Cleaning of
the filter does not extend its life.
5.2.
cleaninG the reSPirator.
After each work period (shift, or working day, etc.) the respirator must be cleaned and prepared for the next period of use. When the
filter is being replaced it is a good opportunity to disassemble the respirator and thoroughly clean it. No special tools are required to
remove any of the components from the face-piece.
5.2.1.
The outer surfaces of the respirator may be cleaned using a cloth dampened with warm soapy water, then dried using a dry cloth.
Do not AlloW WATeR To GeT InTo THe FIlTeR.
8
5.2.2.
Clean the respirator components using warm soapy water.
Do not USE DETERGENTS, THINNERS, SOLVENTS OR PETROLEUM-BASED DISINFECTANTS. TAKE GREAT CARE NOT
8
To dAMAGe THe RUBBeR SeAl on THe InSIde oF THe FIlTeR HoldeR WHIlST CleAnInG.
Inhalation and exhalation valves must be cleaned carefully. Do not stretch or distort the valves as this may cause incorrect
5.2.3.
sealing. Wipe the inside surface of the mask using a mild antiseptic solution, and dry with a clean cloth.
IF AnY deTeRIoRATIon oF VAlVe dIAPHRAGM oR oTHeR RUBBeR CoMPonenTS IS VISIBle, RePlACe IMMedIATelY.
5.2.4.
Rinse in clean, cool water, shake off any surplus water, wipe with a clean dry cloth and allow to dry naturally.
5.2.5.
Once the components are clean and dry, re-assemble the respirator in correct order.
5.2.6.
Fit the correct new filter.
5.3.
StoraGe
Filters should be stored in a dry cool environment away from direct sunlight and contamination. When not in use or during
transportation this filter should be stored in a container such that it is out of direct sunlight, away from chemicals and
abrasive substances and cannot be damaged by physical contact with hard surfaces/items.
environMent Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St edmunds, Suffolk. iP32 7ar
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
SSP1605,SSP1605FP Issue 1 16/01/19
Advertisement
