Advertisement
3.3
Assembling the discharge hose.
3.3.1 Referring to fig.2, slide a wire hose clip over one end of the
discharge hose (9) and push the hose onto the outlet on the
casting in the centre of the lid. Slide the hose clip onto the
fitting and tighten it to retain the hose. See (5A) in fig.2.
3.3.2 Slide the other hose clip over the other end of the discharge
hose and push it onto the dispensing tube (6) adjacent to the
valve. Retain the hose by tightening the wire clip. See (5B) in
fig.2. the dispensing tube (6) is shown partially inserted into
the stowage grommet (7). the tube can be fully inserted into
the lid when not required.
3.4
Assembling the pumping handle.
3.4.1 Attach the handle (1) and link (4) to the lid and pump as shown
in fig.2 using 3 pivot pins (2). Place a flat washer over each
protruding pin and retain each pin with an 'R' clip. See 3 in fig.2.
fig.3
To obtain a parts list and diagram please log on to www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
4. OpeRATION
4.1
4.1.1
4.1.2
Note: only use oils up to SAE 40 viscosity.
4.1.3
4.2
4.2.1 Insert the dispensing tube into the gearbox to be filled. Open
4.2.2
4.2.3
parts support is available for this product.
sole uK Distributor, sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
Filling
Release the three clips which retain the lid and lift it off
complete with the pump which is on the underside of the lid.
Fill the container two thirds full with oil. the maximum level
should be about 2cm below the middle ridge within the
container. Do not fill above this level as the oil may spill during
transportation.
Replace the lid and rotate it so that the pumping handle is
conveniently situated for operation. Fasten the lid down with
the three clips. close the valve on the dispensing tube.
Dispensing
the valve on the dispensing tube.
Pump handle to dispense oil.
When the desired amount has been dispensed, close the
valve and stow the dispensing tube in the hole in the lid.
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
email
tP17
Issue no: 1 - 08/07/10
Advertisement
