Advertisement
7.2.2.
remove the hex headed screw, see fig.16.
Fig.16
7.2.3.
Connect to the air supply and cover the hole with some cloth. Pull the trigger and the oil will leak out of the hole, see fig.17.
7.2.4.
Screw the oil syringe adaptor into the refill hole and inject the new oil slowly, into the hole until it is full. Remove the syringe adaptor
clean the excess oil and replace the hex headed screw, see figs.18 & 19.
Fig.18
7.2.5.
Next test the tool's stroke. If the stroke is still not correct there could still be some air in the oil cylinder from when the tool was refilled.
7.2.6.
to expel the air: pull the trigger 6 or 7 times, loosen the screw, let the extra air leak out then tighten the screw.
recycle unwanted materials instead of disposing of them as waste. all tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
impOrtant: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
environmental protection
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
Fig.19
01284 757500
01284 703534
Fig.17
www.sealey.co.uk
Web
sales@sealey.co.uk
sA317 | issue 1 05/12/16
Advertisement
