Advertisement
Cycle LED
=
Press 3 up then 1 down to cycle through LED status
Switch Mode =
Press 5 up then 5 down if done successfully the LED will blink 5 times
Factory Reset=
Press 3 up then 3 down if done successfully the LED will blink 5 times
Min Threshold = Press 4 down then 1 up, if done successfully the device will turn to 1% and the LED will start to blink
signaling the device is in setup mode. Press and hold up or down to adjust the device to the desired
minimum threshold.
Max Threshold = Press 4 up then 1 down, if done successfully the device will turn to 99% and the LED will start to blink
signaling the device is in setup mode. Press and hold down or up to adjust the device to the desired
maximum threshold.
39351/ZW3010
Parameter and Command Class List
Z-Wave Plus Role Type: Always On Slave
Command Class Z-Wave+ Info, Version 2
Command Class Switch Multilevel, Version 4
Command Class Association, Version 2
Command Class Association Group Info, Version 1
Command Class Manufacturer Specific, Version 2
Command Class Transport Service, Version 2
Command Class Device Reset Locally, Version 1
Command Class Power level, Version 1
Command Class Central Scene, Version 3
Command Class Security 2, Version 1
Command Class Supervision, Version 1
Command Class Configuration, Version 4
Command Class Application Status, Version 1
Command Class Firmware Update Md, Version 4
Button Press Methods
Advertisement
