Advertisement

Weltech Interna onal Limited
Picture is of BW‐2050 Full kit
INTRODUCTION
 
The BW‐2050 has been designed to give the operator complete
flexibility for manual live bird weighing. The BW‐2050 is ba ery
operated and will weigh for up to 15 hours between recharging and
will retain all weights even when the ba ery is flat.

The BW‐2050 can store up to 5000 bird weights.

Weights can be placed into 1‐50 separate stores.

All informa on is stored un l the CLEAR sequence has been
completed.
The maximum weight the unit can weigh is 10kgs (22lbs) for the chicken
version and 50kgs (110lbs) for the turkey weigher.
BW‐2050 Control Panel  
 
 
 
 
 
 
 
 
Printer, Computer and USB (op onal) ports are on the side
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BW-2050 and is the answer not in the manual?

Questions and answers

DEEB ABU JA'EB
May 4, 2025

TYPE OF BATTERY? VOLTS???

1 comments:
Mr. Anderson
May 17, 2025

The WELTECH BW-2050 uses rechargeable batteries. To check the battery voltage or charging voltage, hold the SET UP button down and turn the unit ON; the display will then show the voltage. Specific battery voltage values shown range between approximately 1.998 to 3.020 volts.

This answer is automatically generated

Summary of Contents for WELTECH BW-2050

  • Page 1 The BW‐2050 has been designed to give the operator complete flexibility for manual live bird weighing. The BW‐2050 is ba ery Weltech Interna onal Limited operated and will weigh for up to 15 hours between recharging and will retain all weights even when the ba ery is flat.
  • Page 2: Setup Options

    To reset the weigher back to Factory se ngs hold the MEMORY STORE  Should you need to calibrate the weigher or set a fixed tare weight if bu on and turn on. The display will show WELTECH SET UP un l the using a shackle then follow the instruc ons below.
  • Page 3: Operator Settings

    To set operator se ngs hold the SET UP bu on 100x50 PRINTER LINEFEED ON  down and turn ON, the display will show WELTECH  Sends line feed to printer after a new line SET UP when the bu on is released DATA STORES   will be displayed, by pressing the INC or DEC arrows PRINTER DELAY...
  • Page 4 ON    Shows accepted weight un l ready            DEVIATION METHOD            WELTECH    Universal standards (Weltech)            EVENNESS                  Bernard Ma hews standard ...
  • Page 5 POWER DOWN              15 MINS  OPERATING INSTRUCTIONS   If the unit has not been used it will                  Turn the weigher on by pressing the ON bu on. automa cally turn off a er the pre set To clear data already stored in the weigher press CLEAR, the display will then ask you to press ENTER a er this the display will then ask you to confirm by pressing SET UP, to escape press CLEAR.
  • Page 6 USING THE USB STICK SOCKET  BEFORE MOVING THE WEIGHER TURN IT OFF  Select the WRITE TO USB under the print op ons as seen on page 10. The same procedure is repeated for each house or pen that is to be weighed.  Turn on the WRITE TO USB using the INC or DEC key and put in the USB  ...
  • Page 7: Printer Output

    The printout will show all the birds To check the ba ery voltage or charging voltage. Hold the SET UP 1.980 To 2.000 weighed in 20 gram bands. bu on down and turn ON, the display will show WELTECH SET UP then 2.980 To 3.000 3.000 To 3.020 DATA STORES, press CLEAR and then the INC key. If the INC or DEC key 4.980 To...
  • Page 8 PC OPERATION  KEY PAD  A PC may be connected to the RS232 connector to output the data. Once the computer is connected and the so ware is ready to accept data, then press the PRINT DATA to output the data. USB STICK Socket if fi...
  • Page 9: Remote Commands

    USING THE USB  REMOTE COMMANDS   Turn weigher on and open PRINT OPTIONS, and make sure WRITE TO  The following commands are accepted at the serial port. USB is on. Send id message Plug USB s ck into port (Shown on page 15) and press PRINT DATA. ALL? Send ver cal every bird list for current store Once the file is wri en FILE WRITTEN OK will appear on the screen, the...
  • Page 10: Saftey Considerations

    INDEX  SAFTEY CONSIDERATIONS  The BW‐2050 is a rugged unit designed for outdoor use but it should be handled with care. Subject Page The unit can be cleaned with a damp cloth but under no circumstances Introduc on be immersed in water. Calibra on Carrying the unit by the hook may cause damage to the loadcell and Setup Op ons...
  • Page 11 Weltech Interna onal Limited Weltech Interna onal Limited  manufacture the BW‐2050 to the highest  specifica on and our aim is to con nue  to improve its opera on and reliability  and give our customers a product that  suits their requirements.  SERVICE. For service and repairs contact your local agent. Weltech Interna onal Limited 10 Bramley Road St.Ives Cambridgeshire PE27 3WS Email : info@weltech.co.uk Tel : +44 (0) 1480 461611...

Table of Contents

Save PDF