Sawyer 260 Manual

About Us

We appreciate your business!
Congratulations on your new SAWYER product. We are proud to
have you as our customer and will strive to provide you with the best
service and reliability in the industry. This product is backed by our
extensive warranty and world-wide service network. To locate your
nearest distributor or service agency, please contact us at the phone
number and address listed on the bottom of each page.
You are in good company!
Sawyer Manufacturing Company is the world leader in the design
and manufacture of pipeline and welding equipment and has been
since 1948. Sawyer equipment has become a standard in the industry
and continues to set the benchmark for quality and durability.
This user operation manual has been made to instruct you for the best
use and operation of your Sawyer product. Your satisfaction with our
products is our main goal. Please read this entire manual carefully,
noting all tips, notes and warnings. Safety always comes first.
Parts Diagram
O
A
B
L
K
A. Adjustment Handle
B. Elbow Holding Block
C. Adjustment Handle
D. Fine Adjuster
E. Fine Adjuster Wings
F. Chain Lock Mechanism
Record the following information for warranty purposes:
Where purchased:________________________________________________
Purchase date:___________________________________________________
Equipment Serial #:_______________________________________________
C
N
J-1
G. Chain Pin
H. Jack Bars
I. Chain Tightening Bolt
J. Primary Jack Screw
J-1. Seconday Jack Screw
K. Chain
Sawyer Manufacturing Company
7799 S. Regency Dr., Tulsa, OK 74131 USA
P 918.834.2550
sawyermfg.com
D
!
E
WARNING
alignment only. All reforming and aligning is
M
to be done with primary and secondary jack
screws.
F
G
!
CAUTION:
precision chain clamp for the mating of two
individual pipes together for easier welding.
It is not intended to be used as an individual
support or to lift the pipes. The chain clamp
H
should only be used within its stated size
range. All jack bars should face the same
way and come in full contact with the pipes
I
before final welding.
J
L. Main Block
M. Chain Link Holding Ears
N. Chain Link
O. Elbow Fine Adjuster
P. Main Block Adjustment Wing Nut *not pictured*
* Level & Support Device (combo of A,B,N&O)
All products manufactured by or for Sawyer Manufacturing Company are
guaranteed against defects due to faulty workmanship or materials for twelve
months from the date of purchase.
This guarantee is limited to the repair or replacement of any parts found to be
defective, and no other liability–expressed, implied, or contingent–is assumed.
F 918.834.0318
info@sawyermfg.com
V1.2
Chain Clamp
Manual
Model 260
WARNING
: Alignment handle is for
CAUTION
Sawyer Manufacturing offers a

Warranty

!
!