Advertisement
The
Mitsubishi 915B403001 Lamp
60C9 /WD-65C9 /WD-73C9 / WD-60737 / WD-65737 / WD-73737 / WD-82737 / WD-65837
/ WD-73837 / WD-82837 televisions.
For an environmentally friendly and more economical option, you can also just purchase the
bare lamp that allows you to re-use the existing housing by swapping the old bulb for the
new one.
Replacing the
Mitsubishi 915B403001 Lamp
CAUTION: Burn Danger! Allow the T.V. to cool for one hour before replacing the lamp.
Avoid touching the lamp or lamp cartridge. Use the lamp handles only to remove the lamp.
HELPFUL TIP: Use a pair of rubber gloves during installation. The Mitsubishi
Lamp
lamps does contain mercury, which may end up on your skin. Don't touch the lamp
glass with bare hands as the oil from your fingers may cause premature lamp failure.
PART ONE: Removing the Old Mitsubishi 915B403001 Lamp Cartridge
Loosen the two screws on either side of the
shiniest screws). These screws can only be loosened and not removed completely from
the lamp cartridge.
Take out the bag supplied with the new lamp and open it.
Gently grasp the handle on the lamp cartridge and pull the lamp straight out. DO
NOT TILT, as there may be glass fragments that will fall inside the TV. If this happens,
carefully pick up the larger shards wearing rubber gloves. Take a cloth just damp
enough to pick up the small shreds. It's important to pick up the broken lamps since
this lamp does contain mercury. Read more about proper clean-up from the EPA.
Put the old lamp gently into the opened bag. Close the bag.
SALE on Projector Bulbs at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF
is the recommend model for all Mitsubishi series WD-
for one hour.
cover of the lamp compartment, located at
the back of the TV. Using a #2 Philips
screwdriver, loosen the screw holding the
cover in place. Put the cover to one side.
Turn off the TV and allow it to cool
After TV has cooled, remove the
Mitsubishi 915B403001
915B403001
(they are the
Advertisement
