Advertisement
4. OPERATION
4.1.
Follow the instuctions of the injector puller kit to remove the
particular injector/component fitted to the vehicle.
4.2.
Instead of fitting the slide hammer to the shaft, fit the clamp
and tighten the two hex headed screws to retain it in place
against the handle.
4.3.
Insert the adaptor into the air hammer.
4.4.
Connect the shaft assembly onto the injector/compnent to
be removed.
4.5.
Insert the adaptor/air hammer into the clamp and hold the
hammer with one hand and the handle with the other.
Note: DO NOT point the tool at the face.
4.6.
Use the air hammer for short bursts on a low setting
increasing the vibration level as required.
Note: DO NOT use the trigger lock setting.
4.7.
As the injector begins to move reduce the upward pressure
so the the tool does not fly out.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Environmental Protection
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
Original Language Version
01284 757500
01284 703534
VS2074 | Issue 1 18/11/15
www.sealey.co.uk
Web
sales@sealey.co.uk
Advertisement
