Advertisement
Figure 2
2. Inspect the power cord and plug for damage.
If the plug has been modified, is missing the
grounding prong or if the cord is damaged,
do not use the Drain Cleaning Machine until
the cord has been replaced.
3. Inspect the Drain Cleaning Machine for any
broken, missing, misaligned or binding parts
as well as any other conditions which may
affect the safe and normal operation of the
machine. If any of these conditions are
present, do not use the Drain Cleaning
Machine until any problem has been
repaired.
4. Lubricate the Drain Cleaning Machine, if
necessary, according to the Maintenance
Instructions.
5. Use tools and accessories that are designed
for your drain cleaner and meet the needs of
your application.
The correct tools and accessories allow you
to do the job successfully and safely.
Accessories suitable for use with other
equipment may be hazardous when used
with this drain cleaner.
6. Clean any oil, grease or dirt from all
equipment handles
reduces the risk of injury due to a tool or
control slipping from your grip.
7. Inspect the cutting edges of your tools. If
necessary,
have
replaced prior to using the Drain Cleaning
Machine. Dull or damaged cutting tools can
lead to binding and cable breakage.
8. Inspect cables and couplings for wear and
damage. Cables should be replaced when
they become severely worn or corroded. A
Right: to forward
and controls. This
them
sharpened
or
worn cable can be identified when the
outside coils become flat. Worn or damaged
cables can break causing serious injury.
Machine Set-Up
WARNING
Do not place machine in water. Water entering
the motor can result in electrical shock.
To prevent serious injury, proper set-up of the
machine and work area is required. The
following procedures should be followed to
set-up the machine:
Plug the Drain Cleaning Machine into the
electrical outlet, making sure to position the
power cord along the clear path selected earlier.
If the power cord does not reach the outlet, use
an extension cord in good condition.
Installing Wheels
1. Install retaining clip into groove on one end of
axle.
2. Slide one wheel onto axle with the boss away
from the clip. (See Figure 3.)
3. Fully insert axle through hole in bracket.
4. Slide second wheel onto axle, boss first.
5. Install retaining clip into groove.
Figure 3 – Assembling Wheel
Warning
To avoid electric shock and electrical fires, never
use an extension cord that is damaged or does
not meet the following requirements:
If the wire thickness is too small, the cord may
4
Advertisement
