Maintenance - Craftsman CMECS600 Instruction Manual

English
possible. Position the log in a stable position. Always cut on
the outside of the saw horse arms.
Fig. N
1. Always start a cut with the saw chain running at
full speed.
2. Place the bottom spike
22
area of the initial cut as shown in Figure O.
3. Turn the chain saw on then rotate the saw chain and bar
down into the tree, using the spike as a hinge.
4. Once the chain saw gets to a 45° angle, level the chain
saw again and repeat steps until you cut fully through.
5. When the tree is supported along its entire length, make
a cut from the top (overbuck), but avoid cutting the
earth as this will dull your saw quickly.
Fig. O
22
Figure P- When supported at one end
•
First, cut 1/3 the diameter from the underside
(underbuck). Then make the finishing cut by
overbucking to meet the first cut.
Fig. P
2
1
• Figure Q- When supported at both ends. First, cut 1/3
down from the top overbuck. Then make the finished
cut by underbucking the lower 2/3 to meet the first cut.
10
of the chain saw behind the
CUT FROM TOP (OVERBUCK)
AVOID CUTTING EARTH
2nd CUT OVERBUCK
(2/3 DIAMETER)
TO MEET 1st CUT
(TO AVOID PINCHING)
1st CUT UNDERBUCK
(1/3 DIAMETER)
AVOID SPLINTERING
Fig. Q
• When on a slope always stand on the uphill side of the
log. When "cutting through", to maintain complete
control reduce the cutting pressure near the end of the
cut without relaxing your grip on the chain saw handles.
Don't let the chain contact the ground. After completing
the cut, wait for the saw chain to stop before you move
the chain saw. Always stop the motor before moving
from cut to cut.
Fig. R

MAINTENANCE


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Accessories

WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
Repairs

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including power cord repairs, and brush inspection
and replacement, when applicable) should be
performed by a CRAFTSMAN factory service center or
a CRAFTSMAN authorized service center. Always use
identical replacement parts.
1st CUT OVERBUCK
(1/3 DIAMETER)
TO AVOID SPLINTERING
2nd CUT UNDERBUCK
(2/3 DIAMETER)
TO MEET 1st CUT
(TO AVOID PINCHING)