Page 1
Add casters to a K-series Loom AVL Looms 530 893-4915 2360 Park Avenue 530 893-1372 fax Chico, CA 95928-6785 sales@avlusa.com U.S.A. www.avlusa.com Drill the holes for the casters There are four casters, which should be placed at each corner of the loom. The holes that need to be drilled are size H or 0.266 inch diameter. Two thru holes will need to be drilled for each bracket.
Page 2
Add casters to a K-series Loom Use the rear casters diagram to determine where the holes should be drilled on the rear legs. Mark the position of the hole on the loom. Figure 2 - Drill diagram for rear legs Drill thru the frame at the marked holes using a size H (.266”) diameter bit.
Page 3
Add casters to a K-series Loom Figure 3 - Caster attached to front leg of the loom Place a caster at a rear leg of the loom against the drilled holes, with the bracket facing down. Use the long bolts to secure the casters to the loom.
Page 4
Add casters to a K-series Loom Figure 4 - Caster attached to rear leg of loom Updated: June 8, 2021 Page | 4...