Advertisement
Figure 11.
Figure 13.
Figure 15.
Figure 17.
Figure 19.
product tutorial videos
For detailed specifications,
Figure 12.
Figure 14.
Figure 16.
Figure 18.
Figure 20.
and more, please visit www.photoflex.com
Connecting the SilverDome to a Light Source
NOTE: In most cases, the softbox connector is designed to
connect with your light source in the same manner as your light
source's accessories.
11/12. Connect the light to the softbox connector.
13/14. Carefully lift the softbox and light assembly and position
over the LiteStand. Line up the LiteStand's riser (stud)
with the stand receptacle hole on the light head. Place the
light head on the LiteStand. Tighten the set screws on
your lights swivel to secure to the LiteStand and prevent
unwanted tilt.
15. The inner baffle has elastic bands with metal clips at each
of the four corners. The interior of the SilverDome softbox
has four white nylon loops. Secure one metal clip to each
of these loops.
16. Here is the inner baffle correctly installed in place.
17. The face diffuser is rimmed with Velcro trim that attaches
to its counterpart lining the front of the SilverDome.
Find the long edge of the diffuser and line it up with the
long edge of the SilverDome front. Starting at one corner,
press the face diffuser in place.
18/19. Work your way around the rim of the softbox until the
diffuser is in place.
20. The SilverDome has heat vent flaps on all four sides. For
proper ventilation and to prolong the life of your Silver
Dome, it is recommended that you open up the top
(facing ceiling) vent and bottom (facing floor). This will create a
convection flow of air through the softbox interior.
To prevent unwanted light spill out of the vent, the vent
can be tented in a dome shape to allow air flow.
Customer Support (831) 786-1370
E-mail: sales@photoflex.com
Photoflex is a division of PromarkBRANDS, Bartlett, IL USA.
©2016 ALL RIGHTS RESERVED. SilverDome
Photoflex logo are trademarks or registered trademarks of Photoflex and/or its affiliates
in the U.S. and other countries.
PHOTOFLEX
WARRANTY
®
• Warranties only cover manufacturer's defects and workmanship.
• We reserve the right to inspect all merchandise returned (end
users and dealers) for warranty fulfillment.
• All returns must be pre-approved with Return Manufacturers
Authorization obtained from Photoflex/PromarkBRANDS.
• A receipt showing date of purchase will be required for all returns.
• Freight must be paid by the customer or dealer.
• Warranties are valid only from date of Original Purchase.
, OctoDome
, QRC
, Photoflex
and the
®
®
®
®
REV 09/2016
Advertisement
