HydroTherm DYNAMIC /X8 Installation Manual

DYNAMIC /X8
PLUMBER'S CONDENSED
INSTALLATION GUIDE
150mm
• This unit is designed for external operation only and requires a continuous supply of air to operate efficiently.
• Avoid installation in areas where falling debris, such as leaves, is prevalent as this may result in air vents being
blocked or the unit being damaged.
• Avoid placing the system in locations with multiple walls or structures.
• Always maintain optimum perimeter from all structures.
• The unit should be installed on a concrete plinth or stable structure capable of sustaining weights in excess of
450kg.
• A minimum dimension of 600mm x 600mm is required. Please ensure that all four feet are supported by the
base being used otherwise warranties may be voided.
• The system is to be installed level to ensure that the condensation drainage is not impaired.

1. LOCATION SELECTION

FRONT SIDE
300mm
600mm
HYDROTHERM UNIT
150mm

2. BASE

SUPPLIED CONTENTS
CONDENSATE
DRAINAGE
ELBOW (connected)
OWNER'S MANUAL
OWNER'S
MANUAL
Welcome to the future of hot water.
DYNAMIC /X8
PTR
LEFT SIDE
300mm
pg.1