Advertisement
Step 1: Configuring Your (DEK) Data Encryption Key
1. Press and hold down numbers 1 and 3 while simultaneously
connecting the USB cable to your computer or laptop.
2. The red and green LED lights will turn on after 5 seconds,
then release both buttons. Sequence is as follows:
3. Press and hold (*) for 5 seconds, the orange LED light will
turn on. If the orange LED light does not turn on, it means
configuration mode was unsuccessful.
TIP: Failure to press buttons 1 and 3 simultaneously before connecting
to the computer will result in incomplete DEK set up. If so disconnect the
enclosure and complete steps 1-3 again.
Step 2: Choosing Your Passcode
1. Enter your desired passcode (0 -12 digits) followed by (#)
to save. Both the blue and orange lights will turn off after
successfully setting your passcode.
2. Re-enter your passcode and press (#) to confirm.
3. The blue light will turn on to confirm that your passcode has
been successfully set up.
First Time Set Up
Green light only
After 5 seconds, red and green lights
3
Advertisement
