Technical Specifications - Velleman CAMWH4 Instruction Manual

5. Uninstalling the source board
A. Remove all cables that are connected to the source board.
B. Remove the 4 screws that hold the source board platform in place.
C. Take the platform out of the housing and remove the source board from the platform.
6. Optional Bracket: CAMB10
Attach the bracket to the wall with the enclosed screws.
Attach the camera on the bracket with the E screws (see p.1).
Adjust the camera angle to a suitable position.

7. Technical Specifications

Pick-up element
Number of pixels
Resolution
Min. illumination
BLC
Sharpness
S/N ratio
Electronic shutter
Gamma
Iris mode
Video output
Power source
Power consumption
White LEDs
Effective range
Heater
Operating temperature
Dimensions (L x W x H) 349 x 115.5 x 114mm
Lens (optional)
The information in this manual is subject to change without prior notice.
CAMWH4
1/3" colour CCD sensor
512 (H) x 582 (V) <PAL>
350 TV lines
0.3Lux/F1.2 ; 0Lux/F1.2 (LED on)
on/off
soft/sharp selectable
more than 48dB (AGC off)
1/50 to 1/100.000 sec.
0.45
V.D. / D.D. / AES selectable (lens is optional)
1.0Vp-p composite, 75
100~240Vac ±10% (47Hz~63Hz) switching power supply
12W
18
>15m (F2.0) ; 20m (F1.4)
yes
-20~+60°C
C/CS mounted (e.g. CAML12, CAML13, CAML14, CAML15 etc.)
3 VELLEMAN