Related Manuals for Boss Audio Systems Vision BVH6
Summary of Contents for Boss Audio Systems Vision BVH6
- Page 2 Precautions Please read this manual completely and carefully prior to attempting to install your new car video equipment. Install correctly, your new equipment will provide you with years of enjoyable and safe usage. Installation of this equipment in any portion of a vehicle which impairs or distracts the driver is improper and dangerous.
- Page 3 Control and Layout for the Monitor Blue Screen When No Video Signal Power Cord (Male) Notice: Some functions work by remote control. Adjust Increase 6 INCH LCD MONITOR This multipurpose button serves to increase the selected parameter, such as volume, contrast, etc. Menu This button brings up the on-screen menu for adjustment of range of monitor parameters such as,...
- Page 4 Control and Functions of the Remote Control Power on/off turns on/off the power of the monitor Muting the audio Adjust Up Adjust up to select menu function Adjust Decrease This multipurpose button serves to decrease the selected parameter, such as vol, con, col, bri, tint. This button brings up the on-screen menu for adjustment of a range of monitor parameters such as, vol,...
- Page 5 Function Press system button< the monitor to call out the function menu. PRESS UP < > OR DOWN < > BUTTON TO SELECT > on the remote or press manual button< FUNCTION > twice from Fixed Press left < > or right < > button to select your favorite display language Press left button <...
- Page 6 Games Press < > to enter the games. Start --Menu Button < > Move --Down Button < > Roll --Up Button < > Exit --Mute Button < > Level --AV Button < > Pause --Menu Button < > Move Left --Volume Button < > Move Right --Volume Button <...
- Page 7 Installation Power Cord (Female) Remote Control Replacing Batteries PULL OUT 1) Always use new batteries when replacing the old set. 2)Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 3)Battery replacement is necessary when remote control acts sporadically or stops operating.
- Page 8 Headrest Housing Steps of Installing Headrest Housing Mounting stand CAUTION: make sure the screws are not long enough to go through the headrest! If you have any doubts about this type of installation, please consult your local mobile electronics retailer. Setup work remove the headrest and set it in an uncluttered work area.
- Page 9 Measurements Push on the headrest with your fingers to make sure there are no obstructions that would hinder the installation. Use paper template to mark the area to be cut. Cut the Headrest Using an adjustable-depth blade, start your cut 1/4 inch inside one corner and cut diagonally across, stopping 1/4 inch in from the other corner.
- Page 10 Insert the Monitor Push to insert the monitor to the headrest housing. Route the Cable Through the Headrest Run the supplied cable through the opening and out to the bottom of the headrest. If possible, conceal the wires using a shaft covering. Connect the power, ground and video leads to test the MONITOR.
- Page 11 Operating your system in a safe and legal manner When operating a motor vehicle, it should always be your highest priority to maintain safe driving habits. It is illegal in many areas of most countries to drive with TV or MONITOR turned on, when it is visible to the driver.