Rife mini Instructions And Operating Manual

Hide thumbs

Table of Contents

Quick Links

Download this manual

Instruction and operating Manual

RIFE mini

AZ-92

Please note: We are equipment designers and manufacturers and not practitioners. Always refer any

medical related conditions to a registered medical professional. Check with your medical professional

before using any device. We do not accept any responsibility for the use of our products. It is the

responsibility of the operator of a device to ensure that all safety precautions are exercised. All our products

are deemed for experimental usage and are not in any form or manner to be considered as medical

equipment or devices.

By using our products you accept our terms and conditions of usage and responsibility.

Revision 1.0

E&OE

Table of Contents

Need help?

Do you have a question about the mini and is the answer not in the manual?

Questions and answers

Summary of Contents for Rife mini

Page 1 Instruction and operating Manual RIFE mini AZ-92 Please note: We are equipment designers and manufacturers and not practitioners. Always refer any medical related conditions to a registered medical professional. Check with your medical professional before using any device. We do not accept any responsibility for the use of our products. It is the responsibility of the operator of a device to ensure that all safety precautions are exercised.
Page 2 Switch to the LEFT and the FREQUENCY MODE is selected. • Switch to the RIGHT and the RIFE MODE is selected. • Upon unpacking the unit, remove the battery cover at the rear, and located in the battery compartment are a Probe Tester and a Battery Clip Remover.
Page 3 RIFE MODE This mode is selected when the FUNCTION SWITCH is switched to the RIGHT, the OLED display will display “RIFE MODE PRESS MENU TO CONTINUE...” There are three SCAN modes. The SCAN can be paused at any time resulting in the fundamental frequency being transmitted, plus the harmonics and sub-harmonics of the paused frequency continuously until the pause is interrupted and the scan continues.
Page 4 SCAN 2 = 8 minutes 30 seconds SCAN 3 = 17 minutes While in RIFE mode the audio and Probes output are active. The built-in speaker is not available. External Power Operation Located on the left side of the AZ-92 is a DC socket for connection to an external power pack.
Page 5 LW: 153 - 513 kHz MW: 520 - 1710 kHz SW: 2300 - 21950 kHz <----- This is the important specification, this radio will tune to below the Rife RF carrier frequency of 3.2768mHz Check out Banggood, Amazon and eBay for a portable radio of your choice.

This manual is also suitable for:

Az-92