Belfort ULTIMATE PB111 Information & Operating Instructions

120v

Advertisement

Quick Links

THE ULTIMATE
DO NOT OPERATE MACHINE UNTIL YOU HAVE READ ALL SECTIONS OF THE INSTRUCTIONS
IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY
1. Never use the Booster Heat when solvent is in the machine.
2. Never attempt to heat solvent above 130 °F.
3. Always use a nonfl ammable solvent with a fl ash point of 140 °F or higher.
DO NOT SMOKE WHEN USING HYDROCARBON-BASED SOLVENTS
Even solvents with a fl ash point above 140 °F can be ignited, especially as an aerosol
from the wand.
4. The recovery bucket should be emptied each time the holding tank is fi lled.
5. Always make sure the fl oat travels freely up and down the rod after emptying the recovery bucket.
6. Always vacuum out the stainless steel tank and solution lines when switching from a solvent to a
water based detergent, and vice versa (see Operating Instructions).
7. Always use a drop cloth under the machine during operation.
8. Vacuum any unused solution out of the solution tank and empty the recovery bucket after each job.
9. Keep machine from rain and snow, extremes in temperatures, and store in a heated location.
Use the machine indoors. Do not use outdoors.
10. Do not run the pump dry.
11. Never operate a machine that is leaking or in need of a repair.
12. Always use a defoamer. The vacuum shut-off will not activate properly if foam is in the recovery
bucket. Water damage to the vacuum motor or other components will void the warranty.
If you have any questions before you operate the machine, call your supplier for instruction
EXTRACTOR
120V
: PB111
®
INFORMATION
&
OPERATING
INSTRUCTIONS
.
12-2010

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ULTIMATE PB111 and is the answer not in the manual?

Questions and answers

Summary of Contents for Belfort ULTIMATE PB111

  • Page 1 THE ULTIMATE : PB111 ® EXTRACTOR 120V INFORMATION & OPERATING INSTRUCTIONS DO NOT OPERATE MACHINE UNTIL YOU HAVE READ ALL SECTIONS OF THE INSTRUCTIONS IMPROPER USE OF THE MACHINE WILL VOID THE WARRANTY 1. Never use the Booster Heat when solvent is in the machine. 2.
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS This machine is only suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offi ces other than normal residential housekeeping purposes. When using any electrical appliance, basic precautions should always be followed, including the follow- ing: NOTE: Read all instructions before using this machine.
  • Page 3: Cleaning Solutions

    INSPECTION: Carefully unpack and inspect your #770 Ultimate for shipping damage. Each machine is tested and inspected before shipping. Any shipping damage incurred is the responsibility of the carrier. You should notify the carrier immediately if you notice damage to the box or to the machine or parts. CLEANING SOLUTIONS: The #770 Ultimate is capable of either wet or dry cleaning.
  • Page 4 Set-Up Make sure the recovery bucket is in place under the dome and in the correct position. The dome must be fl at or it won’t seal properly. Fill the stainless steel holding tank with cleaning solution, to the desired level. Solution must be at least 3”...
  • Page 5: Water Heating

    NO SOLVENT WATER ONLY WHEN LIT A = VACUUM B = WARNING INDICATOR C = PUMP D = HEAT E = BOOSTER HEAT 50°C SOLVENT HEATING: Turn on the Heater Switch (D). The Booster Heat switch (E) must be all the way off (turned counterclockwise until it ‘clicks’ off) or the machine will not heat at all.
  • Page 6 32 33 33B 32A THE ULTIMATE Model PBIII 2/22/2010 FORM NO. 56041876 - Page 6...
  • Page 7 ULTIMATE PB111 PARTS LIST ITEM PART # DESCRIPTION ITEM PART # DESCRIPTION FP368 Vacuum Dome, no Gasket Circuit Board, heat control Gasket, for dome Heat Sink Plate Handle, recovery Bucket Grommet FP147 Recovery Bucket, complete Flange, exhaust Float Rod FP487 Filter, exhaust, 4”...
  • Page 8 THE ULTIMATE : PB111 ® EXTRACTOR 120V NOTES:...

Table of Contents