Advertisement
Available languages
Available languages
Table of Contents
Installation
1: Checking before installation (There's electricity in the solar lighting when you receive, need to check if it
works before installation)
-- Connect the light and solar panel, put solar panel to the place with bright lighting, led light's off, cover solar
panel and light's on, that shows the lighting sensor of solar panel and the light are working.
-- Stand 5 meters far from the lighting and put "on" and "off" towards the light to check the remote using.
2: Installation of solar panel
a, place solar panel on the roof (recommand way)
b, put solar panel on the wall
-- Fix the stand and solar panel first
-- Fasten the solar panel on the wall with the expansion screws and make it in an angel of about 45°up to the
sky, make it clear without any covers
3: Installation of led lighting
-- Fasten the led light on the wall with the expansion screws
-- Adjust the angle with your actual situation
4, Connect male and female connector and screw the waterproof cover, installation completed.
5, Check after installation if everything fastened and worked.
INSTRUCTION MANUAL
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for DDC 1307950
- Page 1 INSTRUCTION MANUAL Installation 1: Checking before installation (There’s electricity in the solar lighting when you receive, need to check if it works before installation) -- Connect the light and solar panel, put solar panel to the place with bright lighting, led light’s off, cover solar panel and light’s on, that shows the lighting sensor of solar panel and the light are working.
- Page 2 Warnnings 1, Lighting on with 12 hours need to be in the condition of full electricity charged in the battery. 2, Clean the dust on the solar panel and check the connection of the light periodically. 3, Use remote to control the brightness in continuous rainy day and cloudy day. 4, Do not connect a new solar panel which is over 6V to the led lighting.
- Page 3 NOTICE D’UTILISATION 1- verifier avant installation, (la batterie est legermeent chargé lorsque vous recevez votre produit, verifies qu’il fonctionne correctement) -Connectez le projecteur au panneau solaire, placez le panneau solaire a un endroit bien exposé au soleil, le projecteur est éteint. Couvrez le panneau solaire, le projecteur s’allume. Cela montre le bon fonctionnement des capteurs et des Leds.
- Page 4 Attention, 1) Pour un éclairage de 12H, la batterie doit etre completement chargée. 2) Nettoyer regulierement le panneau solaire et verifies le bon état des connections. 3) Utiliser la telecommande pour affiner la puissance d’eclairage selon les conditions d’ensoleillement 4) Ne pas connecter u autre panneau solaire que celui fourni. Remarques : 1) Le projecteur s’allume automatiquement dans un endroit sombres ou a la tombé...
Need help?
Do you have a question about the 1307950 and is the answer not in the manual?
Questions and answers