Advertisement
Quick Links
Advertisement
Summary of Contents for Sebury sGuard
- Page 1 User Manual...
- Page 2 1. Technical parameters and functional features power supply requirements: DC12V ≥ 500mA Static working current: ≤ 100mA Working current of external access control: ≤ 200mA (over current and short circuit protection) Accuracy of working current of standalone access control or card reader: ±1mA...
- Page 3 "all-in-one machine", and turn the "power switch" SW7 from "off" to "on". Until the machine enters the standby status, the following tests can be started. sGuard Wiring 1 2.2 function test Under normal conditions, green LED1 is off, red LED2 is on, red LED3 and LED4 are off. The first four digits of the nixie tube display the working current of the standalone access control within 3 minutes of power on.
- Page 4 K1 to the "card reader", and turn the "power switch" SW7 from "off" to "on". After the machine enters the standby state, the following tests can be started. sGuard Wiring 2 3.2 Card Reader Operating Current If no operation within 3 minutes after power-on, the first 4 digits of the nixie tube display the working current of the external card reader, then end display and enter into sleep mode.
- Page 5 3.3.2 Card Reader Setting Currently, card reader models can be set by sGuard are: R1/2/3/4 Series, mReader, sReader. Function test is applicable for other models card readers instead of setting up. Press Card reader set up key “SW5” once then release, the card reader indicator wills turn into orange and LED10 light will turn on.
- Page 6 13: Read IC card. 14: Read EM, HID and IC card. Card number output format selection (mode 1): 26-37: Wiegand 26-37 has a parity bit card number Card number output format selection (mode 2): 27-35: Wiegand27-35 No parity card number 3.3.3 Card Reader Test Card reader outputs the Wiegand signal when swiping the card, the first and second digit of the nixie tube display 26-37, the third digit displays ”-”, The 15-16th digit displays the card number format.
- Page 7 4 Infrared Remote Controller (IRC) key internal code data test sGuard can test the Remote controller of IRC of F007-II、F007EM-II、sPress、W2、W2-A. Aim the remote controller at infrared receiver U3, the 6 digital showed on the right side of the digital tube will display the IRC key number as follows: Key1：01-000,...