Radio Operation - Boss marine MR2020G User Manual

OPERATION
start to listen to the FM1 89.8Hz.
Note: In CDC mode, the unit can't
memorize the track number and disc
information.
• RESET
When you pull out the plastic panel
covering the CD opening, you will see
the reset button (26) is placed above
the disc slot (5). It must be activated
with either a ballpoint pen or thin metal
object. The reset button is to be
activated for the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not
operate.
- Error symbol on the display.

RADIO OPERATION

• BAND SELECTION
At tuner mode, press BAND button
(18) shortly to select the desired band.
The reception band will change in the
following order:
FM1 FM2
• STATION SELECTION
Press TRK/TUNE
TRK/TUNE
activate automatic seek function.
Press for more than 3 seconds until
"MAN" appears on the display, the
manual tuning mode is selected. If both
buttons have not pressed for several
seconds, they will return to seek tuning
mode and "AUTO" appears on the
display.
• AUTOMATICALLY MEMORY
STORING & PROGRAM SCANNING
- Automatic memory storing
Press AS/PS (ELAPSE) button (2) for
more than 2 seconds, the radio
searches from the current frequency
and checks the signal strength until
6 strongest stations are stored into
the corresponding preset number
button. When all completed, it will
change to scan preset station
FM3 AM1
button (16) or
button (17) shortly to
automatically.
- Program scanning
Press AS/PS (ELAPSE) button (2)
shortly to scan preset station. The
radio is holding at that preset number
for several seconds, and then
searches again. Press AS/PS
(ELAPSE) button (2) again to stop
scanning when desired station is
reached.
• STATION STORING
Press any one of the preset buttons
(14) (M1 to M5) (i.e.20~24) to select a
station which had been stored in the
memory. Press this button for several
seconds, current station is stored into
the number button.
• MONO/STEREO
Press MODE button (25) to select
mono or stereo reception of stations.
You can sometimes improve reception
of distant stations by selection mono
operation.
• SCAN
Press SCAN button (13) to scan
through strong stations in the current
band. Radio pauses for five seconds
at each strong station. At each time
the frequency is flashing on the display.
Press SCAN button (13) again to listen
to current station.
• SELECTABLE FREQUENCY
SPACING (FOR USA VERSION ONLY)
Programs the unit for USA or European
radio frequency spacing. While in radio
mode, pressing and holding BAND
button (18) and then pressing
TRK/TUNE
TRK/TUNE
between USA or European frequency
spacing.
- Pressing and holding BAND button
(18) and then pressing TRK/TUNE
button (17) selects USA frequency
spacing.
- Pressing and holding BAND button
(18) and then pressing TRK/TUNE
button (16) selects European
frequency spacing.
7
button (17) or
button (16) toggles