Panasonic AW-HE40 Quick Start Manual page 2

3. By [5] AUTO SET IP setting, execute the automatic assignment of IP addresses. (RENEW IP ADR)
①
In the state of the above-mentioned 2.-②, turn F1dial to select [5] AUTO SET IP.
②
Press F1 dial to make [RENEW IP ADR] appear on the lower half of the LCD screen.
* If it does not appear, turn F2 dial to make [RENEW IP ADR] appear.
③
While [RENEW IP ADR] is displayed, press F2 dial. The number of units that AW-RP50 has newly
detected and the number of units that it currently manages (all the remote cameras and switchers) will
be displayed on the upper half of the LCD screen.
④
[NO] will be displayed on the lower half of the LCD screen. So, turn F2 dial to select [YES] and then
press F2 dial.
⑤
When [COMPLETE] is displayed on the lower half of the LCD screen, the setting-up is completed.
MENU ON ⇒ Select [10]
［1］CAMERA CTL
[5] AUTO SET IP
1. AUTO SET
After setting up, LED button 4 (CAM4) at <CAMERA STATUS / SELECTION> on the AW-RP50 operation panel lights
up in a few seconds according to the camera's power status. If the camera is in STANDBY mode (power OFF:
factory default), the button lights up in orange. If in POWER ON mode (power ON), it lights up in green.
* When the camera is in STANDBY mode, the Power-ON operation needs to be done.
For the procedure, please refer to "3. Turn AW-HE40 on" of the Manual 【Controlling AW-HE40 Camera via
AW-RP50 Controller】.
After setting up, this lights up
according to the camera's
power status.
* If it does not light up, please check the following points.
① Check the connection state of LAN cable or whether you are using a cable that meets the specifications.
② Check that the LAN cable is connected to "LAN port", not to "RS422 port".
③ Double-check that there is no error in setting up the connection.
Turn F1
Press F1
RENEW IP ADR
(AW-RP50: CAMERA STATUS/SELCTION Area)
C:001/004
Turn F2
Press F2
C:001/004
Press F2
C:001/004
S：0/1
NO ↓
S：0/1
YES
↓
S：0/1
COMPLETE