Taymor 06-9523SBDT Installation Instructions

INSTALLATION INSTRUCTIONS
06-9523SBDT
ASTRAL DIVERTER VALVE TRIM KIT
THIS FAUCET MEETS OR EXCEEDS THE FOLLOWING STANDARDS:
cUPC, ASME A112.18.1
THANK YOU FOR PURCHASING THIS TAYMOR PRODUCT. ALL TAYMOR PRODUCTS ARE CAREFULLY
ENGINEERED AND FACTORY TESTED TO PROVIDE LONG TROUBLE-FREE USE UNDER NORMAL CONDITIONS.
HAVE BASIC TOOLS READY
RECOMMENDED TOOLS:
Teflon
Screw- Adjustable and Hand
drill
tape drivers Pipe wrench
WARNING: READ ALL the instructions completely before beginning.
READ ALL warnings, care and maintenance information.
Taymor recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and provincial plumbing and building codes.
Need Help? Please call our toll-free Customer Support line at
(WEST) 1-800-267-4774 (EAST ) 1-800-387-7064 for additional assistance or service.
TURN OFF THE MAIN WATER SUPPLY
Locate water supply inlets and shut off water supply valves.
TURN OFF
Flashlight Torque Safety Plumber's
goggles putty
wrench
TURN OFF
1
Recommended valve depth is 1-1/2" min. to
2-1/2" max. from the center of the diverter
to the finished wall as shown.
1
2 Place the handle
Adjust handle to make water flow from
" " only position. Remove the
OUTLET 1
handle.
3
Postion the escutcheon
diverter body with the drain hole
the bottom. Place the handle onto the
diverter body and make sure the handle
is upright and then tighten the handle
seat .
3
4 Adjust handle position to control flowing pattern.
Silicone
caulk
Water flow from
OUTLET 1
5 EXPLODED DIAGRAM FOR REFERENCE
MAINTENANCE Your new faucet is designed for years of trouble-free performance.
Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners,
steel wool and harsh chemicals as these will dull the finish and void your warranty.
NUT
INVERTER
INVERTER
CUSTOMER SERVICE WEST 1-800-267-4774 | EAST 1-800-387-7064 | taymor.com
1-1/4"
(31.1 mm)
FINISHED WALL
DIVERTER
VALVE
FINISHED WALL
1-1/4"
(31.1 mm)
PRO/VALVE BODY
FINISHED WALL
OUTLET 3
on the diverter 2 .
1
1
3
1 onto the
at
2
Water flow from
OUTLET 2
WASHER
WASHER
FLANGE
SLEEVE
HANDLE SEAT
O-RING
HANDLE
® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD.
1-1/2" 2-1/2"
-
(38 mm) (83.5 mm)
1-1/2" 2-1/2"
-
(38 mm) (83.5 mm)
OUTLET 1
OUTLET 2
2
OUTLET 1
OUTLET 3
OUTLET 2
2
Water flow from
OUTLET 3
WASHER