Advertisement
Quick Links
71000R - 1000 LB Rotating Engine Stand with Tool Tray
Owners's Manual & Safety Instructions
www.jackco.com
SPECIFICATIONS
Rated Capacity
Net Weight
Shipping Weight
Gear Ratio
Visit our website at: http://www.jackco.com
Email our technical support at: contact@jackco.com
1000 lbs.
90 lbs.
97 lbs.
60:1
Advertisement
Summary of Contents for Jackco 71000R
- Page 1 71000R - 1000 LB Rotating Engine Stand with Tool Tray Owners’s Manual & Safety Instructions SPECIFICATIONS Rated Capacity 1000 lbs. Net Weight 90 lbs. Shipping Weight 97 lbs. Gear Ratio 60:1 Visit our website at: http://www.jackco.com Email our technical support at: contact@jackco.com...
- Page 2 Adequately support the vehicle before starting any repairs. Never loosen mounting head bolts or engine mounting bolts unless engine is supported by a crane or hoist. Only attachments and/or adapters supplied by Jackco shall be used. Do not use stand to dolly or transport engine.
- Page 3 Setup Install the casters to the front (10) and rear legs (09) using the hardware items (19, 20, 21 & 22). Be sure to insert bolts from the bottom side of caster plate IMPORTANT: All hardware that assembles items 01, 02 & 04 together should be assembled loosely to ensure all bolts and pins fit through their designated holes.
-
Page 4: Preventative Maintenance
Setup OPERATING INSTRUCTIONS This is the safety alert symbol used for OPERATING INSTRUCTIONS section of this manual to alert you to potential personal injury hazards. Obey all instructions to avoid possible injury or death. OPERATION: 1. Consult the vehicle or engine manufacturer for service manuals and or technical bulletins that provide information on suggested engine mounting tips, proper size and type mounting bolts and the engine’s center of balance. -
Page 5: Assembly Diagram And Parts List
Assembly Diagram and Parts List Parts List Part Description Part Description Part Description Front Beam Bolt M12*85 Middle Beam Washer 12 Block Rear Beam Spring Washer 12 Bolt M10*16 Main Post Nut 12 Bushing Lubricating Fitting Bolt M8*20 Bearing Cover Bolt M6*16 Washer 8 Head Assembly... -
Page 6: Limited One Year Warranty
No other warranties, expressed or implied, including those of merchantability or fitness for particular purpose shall be applicable to Jackco except as specifically stated herein. In no event shall Jackco be liable to any party for any special, direct, indirect, consequential, punitive damage of any nature caused by the sale or use of the equipment or tool.