LevelCon F100 Setup Instructions

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

B asics

● The F100W-LPG (F100) sends LPG tank level information to an email address using the

WiFi network where an LPG tank is located.

● The F100 unit can be setup without being in range of the WiFi network at the LPG tank.

● The F100 creates a temporary WiFi network for Setup.

● You will need to know how to search for and connect to WiFi networks with a

smartphone, tablet, or similar device. Setup requires Javascript.

For setup you will need:

● Network name and password of the WiFi network at the LPG tank.

● Email address reports will be sent to.

● Name assigned to the LPG tank.

You may find it handy to have this information at your fingertips -

F100 Configuration Page:

Network Name: _ _________________________________________________

Password: _ _____________________________________________________

Email addresses for reports: _ _____________________________________

Unpack and Assemble

1) Remove components from packaging.

2) Remove black tab from Propane Tank Dial and insert Hall Effect Sensor.

3) Remove protective cover from F100 connector, by turning cap counterclockwise.

4) Connect sensor cable to monitor, take care to observe alignment slots.

5) Monitor with sensor connected.

LevelCon - product brand of Micro-Design, Inc. 10210 Monroe Rd. Dallas, TX 75229

F100 Basic Setup Instructions

1 92.168.10.1

T: 972-488-8725 Website: levelcon.com

F 100LPG 1.19.17

Table of Contents

Need help?

Do you have a question about the F100 and is the answer not in the manual?

Questions and answers

Summary of Contents for LevelCon F100

Page 1 ● The F100W-LPG (F100) sends LPG tank level information to an email address using the WiFi network where an LPG tank is located. ● The F100 unit can be setup without being in range of the WiFi network at the LPG tank. ● The F100 creates a temporary WiFi network for Setup.
Page 2 Setup - Connect to the F100 For Setup, the F100 will create a temporary WiFi connection with a WiFi enabled, web enabled, device like a smartphone or laptop. This temporary connection is used only for setup. 1) P ress the push button for 4-5 seconds, then release.
Page 3 2) Report Rate The F100 is preconfigured to report once per day. (Report Rate value of 86400.) This is the report rate LevelCon recommends. To accept this, do nothing. Proceed to the next step. For 2 reports per week enter 302400 in the textbox.
Page 4 A single, quick depression of the push button will send a report. This also resets the timer. This method of reporting draws a lot of energy from the battery, and minimal use is recommended. LevelCon - product brand of Micro-Design, Inc. 10210 Monroe Rd. Dallas, TX 75229 T: 972-488-8725 Website: levelcon.com ...
Page 5 2. JavaScript. JavaScript is required for administering the F100. 3. Advanced b utton. The A dvanced button reveals all possible set up parameters of the F100. LevelCon does not recommend using this option for normal consumer installations.
Page 6 If required, reconnect the battery connector as shown in the picture. Orient the F100 so the Push Button is on your left. Insert the battery cable connector onto the seven pin connector so the black wire is on pin 1 (leftmost pin), and the red wire is on pin 4.