Operation; Cleaning And Storage - Duracraft DFT-218W Owner's Manual

12” oscillating table fan
Table of Contents

Advertisement

Available languages

Available languages

OPERATION

• Be sure your fan is in the OFF position (O).
• Place your fan on a level and dry surface.
• Plug the power cord into a polarized 120 Volt AC wall outlet.
• To operate, turn the Speed Control Knob to the desired position: HIGH (III),
MEDIUM (II), LOW (I) (Fig. 6).
• Tilt the fan head to desired angle.
• To activate or disengage the fan oscillation, push down or pull up the Oscillation
Control, respectively (Fig. 7).
Fig. 6

CLEANING AND STORAGE

• Unplug the fan before cleaning.
• Use only a soft, damp cloth to gently wipe the fan clean.
• DO NOT immerse the fan in water and never allow water to drip into the motor
housing.
• DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
R E M O V A L O F T H E F R O N T G R I L L E F O R C L E A N I N G
• Remove the Front Grille by unsnapping the Front Grille from the Rear Grille.
• Unscrew the Blade Knob by turning it CLOCKWISE (REVERSE THREAD).
• Pull the Fan Blade away from the Motor Housing.
• Gently wipe the Fan Blade and grilles with a damp cloth.
• Re-assemble the fan by following the last three steps in ASSEMBLY
INSTRUCTIONS.
• For storage, disassemble and clean the fan carefully as instructed and store in its
original box. You may leave the fan assembled and covered to protect it from dust.
Store the fan in a cool, dry place.
Fig. 7

Advertisement

Table of Contents
loading

Table of Contents