Bosch HMB402 Installation Instructions Manual page 6

Step 4: Installing The Microwave Oven (continued)
Step B
1. Remove the one existing screw from the left side of the microwave oven.
2. Connect the side duct to upper duct as shown.
a) Insert projecting tabs of upper duct into holes of side duct.
b) Bend tabs up as shown.
NOTE: Remove any oil or dirt on surface of microwave oven before ducts are attached.
Upper Duct
a)
3 tabs
3. Peel off the backing of double-sided tape. Attach
the side duct and upper duct assembly on the mi-
crowave cabinet. Press down firmly on ducts. Fas-
ten duct assembly to left side of cabinet with one
existing screw.
Step C
1. On the cutout floor, mark hole centers for the
anti-tip brackets as shown using the supplied
template. Be sure to align the center line of tem-
plate to center line of cutout floor.
2. Drill two holes for anti-tip bracket. (Use
or #35 drill)
3. Install anti-tip bracket onto cutout floor using two
1
/ " screws.
2
DIMENSIONS:
-1
A = 4 / "
4
B = 3"
-3
C = 18 / "
16
b)
3 holes
Side Duct
Existing
Screw
7 / " drill
64
6
Centerline
Cutout Floor
1/2" Screws (2)
Anti-tip Bracket