Tiger Electronics Pokemon 89-104 Quick Start Manual

GAME INCLUDES: 1 battle arena, 2 tops, 16 Pokémon character
disks (stored in the bottom of the unit)
Which Pokémon is stronger? With Tiger's electronic Pokémon
Challenge, you can find out!
FLIPPER
CONTROL
KNOBS
LAUNCH
ARM
TOPS
INSERTING THE BATTERIES
Using a Phillips® screwdriver,
loosen the screw on the battery
compartment door located on the
bottom of the unit.
Remove the battery compartment door.
Insert four (4) AA batteries, making
sure to align the "+" and "-" signs.
Loosen the battery compartment door
and screw.
TO ENSURE PROPER FUNCTION:
- Do not mix old and new batteries.
- Do not mix alkaline, standard or
rechargeable batteries.
- Battery installation should be done by adult.
- Non-rechargeable batteries are not to
recharged.
- Rechargeable batteries are to be removed
from the toy before being charged
(if removable).
- Rechargeable batteries are only to be
charged under adult supervision.
- Only batteries of the same or equivalent
type as recommended are to be used.
- Batteries are to be inserted with the
correct polarity.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
Replace with new batteries at the first sign of
erratic operation.
AGES 5 & UP
MODEL 89-104
LAUNCH
BATTLE
BUTTON
ARENA
WIND UP
BUTTON
POKÉMON
CHARACTER DISKS
AA/LR6 1.5V
AA/LR6 1.5V
AA/LR6 1.5V
AA/LR6 1.5V
OBJECT OF THE GAME
Collect the most Pokémon character disks and you win!
LET'S GET READY
1. Turn over the unit, squeeze the latch and lift the door on
the character disk storage space. Remove the character disks
and close the door.
Place unit face up on the table.
CAUTION: Do not press down on the unit while it is
2. Divide the character disks evenly between both players.
Choose a character disk for your top. The base of your top
should be the same color as the launch arm and flipper
control knobs that you are using.
3. Remove the clear plastic cover from the top. To do this,
turn it counter-clockwise until it stops, then use the ribs
LAUNCH
BASE
to lift.
4. Place the character disk in
the top so that the
Pokémon is facing you.
FLIPPER
5. Replace the clear plastic
cover by aligning the tabs
on the cover between the
slots in the base.
Turn the lid clockwise until
the tabs are locked into
the slots.
6. Raise the LAUNCH ARM by pressing the LAUNCH BUTTON.
Your LAUNCH ARM should be the same color as your top.
7. Insert the point of the top
into the LAUNCH BASE,
making sure that it is
centered.
upside down or you may break the launch
arms.
TAB
SLOT
OPEN
CLOSE