Summary of Contents for Haneco SKYLUX Smart Control
Page 1
HANECO LED HIGHBAY INSTALLATION GUIDE SKYLUX / Sensor & Remote INTELLISENSOR Smart Control Microwave motion sensor with corridor function (SKYLUX-MS) Note: Sensor and remote control available separately as accessories. The sensor can only be configured via a remote controller. Default sensor setting without remote controller...
Page 2
Press for factory reset. Pre-set configurations can be updated and saved within the four modes. Default: Brightness 100% Daylight sensor Disabled Sensitivity 100% Stand-by dim Hold time 5 min Stand-by period 60 min For more information www.haneco.com.au 1300 001 LED (533) ART09122019...
Page 3
Configure new MODE 1. Press “MODE 1, 2, 3 or 4”. The remote will display existing configurations. 2. Press to select new parameters. 3. Press “OK” to confirm all parameters and save. For more information www.haneco.com.au 1300 001 LED (533) ART05062019...
Page 4
• The warranty is void if product is not installed according to the instructions. Note: Product technical information and specification may change over time without prior notice. For latest information, please contact our customer service or visit our website www.haneco.com.au For more information www.haneco.com.au...