Advertisement
SPECIFICATIONS, ASSEMBLY INSTRUCTIONS
SPECIFICATIONS
Overall dimensions
Tank dimensions
Max. solvent capacity
Pump output through hose
Electrical requirements
Gross weight
ASSEMBLY INSTRUCTIONS
1. Remove machine from the carton and inspect for any visual damage.
2. Remove parts from inside the machine.
3. Lay clean cardboard on floor and lay machine on its lid. (Make sure you hold the cover closed when laying the machine on its lid.)
4. Mount four legs on brackets with Phillips head screws and nuts. Note: Do not tighten.
5. Place lower shelf between legs with flat surface down and attach to legs with Phillips head screws and nuts.
6. With legs pressed tight against lower shelf, tighten all screws to lower shelf.
7. Tighten all screws installed in step 4.
8. Stand machine up, being careful to hold the lid closed.
9. Place work shelf and basket into the machine.
10. Mount pump assembly into slot on the side of the machine. Place filter screen in position.
11. Plug machine into standard 120 Volt/60Hz grounded outlet and fill with proper amount of fluid.
12. Turn switch on. Fluid should now be flowing from the flexible hose.
WARNING!
* Use in well ventilated area.
* Do not use highly volatile flammable solvents such as gasoline.
* Use protective measures when necessary.
* Avoid solvent contact with skin and eyes.
THE MANUFACTURER RECOMMENDS USING WATER BASED SOLVENT-FREE DETERGENTS, DEGREASERS AND CLEANERS. DO
NOT USE ANY OTHER KIND OF SOLVENTS OR IT MAY DAMAGE THE PUMP.
WARNING
The pump for the parts washer may be damaged if you use solvents such as Methyl ethyl ketone (MEK), Perchloroethylene or
trichlorolethylene.
TROUBLE SHOOTING
The only trouble you should ever experience with your parts washer is reduced volume flow or no flow of cleaning liquid from flexible hose.
The probable cause is foreign matter in the flexible hose.
CORRECTIVE PROCEDURE
1. Check that indicator light on switch box is lit.
2. Using an insulated handle screw driver to lightly touch the tip of the motor housing. A light oscillation magnetic pull indicates power is
reaching the motor.
3. Disconnect the power plug, remove flexible hose from pump flow-out line.
4. Remove front of pump housing by removing the 3 screws. Clear any foreign matter lodged around the impeller.
5. Re-assemble in the opposite order.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.
& MAINTENANCE
RECIRCULATING PARTS WASHER
30-3/4'' X 21-1/4'' X 35-3/4''
29-7/8'' X 20-3/4'' X 10-8/10''
20 Gallons
50 GPH (Gallons Per Hour)
120V/60Hz
28 Kgs.
Advertisement
