Radio switching actuator for flush mounted installation (4 pages)
Summary of Contents for GEIGER GFU004
Page 1
Venetian Blind Control GFU004 for flush mounted installation GFU004 Operating instructions...
Page 2
1. General The GFU004 is a Venetian blind control for flush-mounted installation. It has connections for two external push-buttons, for the tubular motor and for the mains connection. The operation and the control installation are effected via operating button, radio transmitter, sun/ wind / rain / service radio sensors and an internal programming button.
Page 3
Upon the reception of the sensor commands „wind“ or „service“, a retract command is triggered and a certain pre-programmed disable time starts running. No operation can take place during the disable time, as both the sun and the twilight sensor are disabled. www.geiger.de...
Page 4
A single radio code cannot be deleted. See „delete learned transmitters.“ 2.9 Factory setting The device is delivered pre-coded with GEIGER coding. For the first learning, the GEIGER code will be replaced by a transmitter code. Set the individual code on the handheld transmitter via DIP switch (see operating instructions handheld radio transmitter).
Page 5
5. Declaration of Conformity The Declaration of Conformity concerning this product is available on our website: www.geiger.de. 6. Connection Diagram These buttons must be potential-free. Please do not use here 230 V. This would damage the control. Mass Button _ | In2 In1...
Page 6
They will be happy to assist you. Gerhard Geiger GmbH & Co. KG Schleifmühle 6 | D-74321 Bietigheim-Bissingen T +49 (0) 7142 9380 | F +49 (0) 7142 938 230 info@geiger.de | www.geiger.de Gerhard Geiger GmbH & Co. KG | 100W0652 0221...