Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ross Vision CompactFlash
Summary of Contents for Ross Vision CompactFlash
- Page 1 Ross Video Limited CompactFlash Installation Guide...
- Page 2 Notice The material in this guide is furnished for informational use only. It is subject to change without notice and should not be construed as commitment by Ross Video Limited. Ross Video Limited assumes no responsibility or liability for errors or inaccuracies that may appear in this guide.
- Page 3 To avoid the potential release of those substances into the environment and to diminish the need for the extraction of natural resources, Ross Video encourages you to use the appropriate take-back systems. These systems will reuse or recycle most of the materials from your end-of-life equipment in an environmentally friendly and health conscious manner.
-
Page 4: Package Contents
Package Contents The contents of a CompactFlash replacement kit is listed below. If any items are missing, or damaged, contact Ross Video Technical Support. Part# Item 726-165R 4GB CompactFlash with Vision software 3 • Package Contents... - Page 5 CompactFlash Replacement The CompactFlash (CF) in the Vision control panel holds all the software required for the control panel to operate. To replace the CF, you must first record the network address of the control panel and frame, power off the control panel and then replace the CF.
-
Page 6: Replacing The Compactflash
Replacing the CompactFlash To replace the CF, you must power down the Vision control panel, remove the CompactFlash access plate, remove the old CF, insert the new CF, and replace the CompactFlash access plate. Use the following procedure to replace the CF in the Vision control panel: Power down the control panel. - Page 7 Push in the Ejector Button to the left of the CompactFlash to eject the CompactFlash from the CF Slot (Figure 3). Remove the old CompactFlash from the CF Slot and return it to Ross Video. Compact Flash Ejector Button Figure 3 CompactFlash Ejector Button Align the CompactFlash so that it is face down, and slide it into the empty CF Slot until the Ejector Button pops out (Figure 4).
-
Page 8: Control Panel Configuration
Control Panel Configuration When the Vision control panel is powered on after replacing the CF, you must enter the network addresses for the control panel and frame, and assign the control panel modules to the control panel rows. Network Setup The Network setting for the switcher are stored on the CF in the Vision control panel. -
Page 9: Module Setup
Module Setup The assignment of the modules to control panel rows is stored on the CF. When the new CF is installed, the modules on the control panel must be re-assigned. Refer to your Vision Engineering Manual for information on upgrading your Panel Module Controllers (PMCs) and assigning the modules to a panel row. - Page 10 Notes 9 • Control Panel Configuration...
- Page 11 Notes Control Panel Configuration • 10...
- Page 12 613 • 349 • 0006 613 • 652 • 4425 General Information solutions@rossvideo.com E-MAIL Technical Support techsupport@rossvideo.com 8 John Street, Ross Video Limited Iroquois, Ontario, Canada K0E 1K0 POSTAL SERVICE P.O. Box 880, Ross Video Incorporated Ogdensburg, New York, USA...
Need help?
Do you have a question about the Vision CompactFlash and is the answer not in the manual?
Questions and answers