Maintenance - Saba CB309BK Manual

2. The component that could be swapped over from one side to
the other only after reconstruction is listed below:
– top hinge assembly
3. Components that could be swapped over from one side to
the other in pairs are listed below:
– adjustable foot with internal thread (used with the lower
hinge)
– adjustable foot with bolt (fixed at the bottom)
4. Components that could not be reused temporarily are listed
GB
below:
– left fridge door stop
– right fridge door stop
Note:
Ensure the Appliance is unplugged and empty. Adjust the two
leveling feet to their highest position.
We recommend you have someone to assist you.
To take the door off it is necessary to tilt the Appliance backward.
You should rest the Appliance on something solid e.g. a chair just
below the top panel.
Do not lay the Appliance completely flat as this may damage the
coolant system.
16

Maintenance

FRIDGE DEFROSTING
The fridge defrosting process is carried out automatically every
time the compressor stops.
The defrost water is automatically routed to the drain port and
into a tray placed on the top of the compressor to the rear of the
appliance from which it evaporates.
Make sure the drain port on the fridge at the rear of the appliance
is kept clear.
FREEZER DEFROSTING
Frost will accumulate inside the freezer depending upon the
length of time during which the door is left open or the amount of
moisture introduced.
It is essential to ensure that no frost or ice is allowed to form at
places where it will affect the close fitting of the door seal.
Tis might allow air to penetrate the cabinet, thus encouraging
continuous running of the compressor.
Tin frost formation is quite soft and can be removed with a brush
GB
17