Installation To Single Wood Stud Wall - Paramount Fitness PT630 Installation And Assembly Manual

Installation to Wood Stud Wall
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is
highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of mounting situations (not UL approved).
Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended. Based
1
on its edges, draw a vertical line down the stud's center. Place wall plate (A) on wall as a template, making sure that
the two mounting holes are on the stud centerline. Level wall plate, and mark the center of the two holes. Drill two 5/
32" (4 mm) dia. holes 2-1/2" (65 mm) deep. Make sure that the wall plate is level, secure it using two #14 x 2-1/2"
wood screws (D) as shown.
Skip to step 2
WARNING
A
D
4 of 24
STUD
ISSUED: 11-19-07 SHEET #: 202-9245-1