Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Evil Pimp Kit
Summary of Contents for Evil Pimp Kit
- Page 1 ™ ™ Version 1.0...
- Page 2 MUST BE WORN BY ALL PERSONS WITHIN RANGE WHEN A PAINTBALL MARKER paintball markers can be directed to Pursuit Marketing Inc., or visit www.evil-paintball.com IS IN USE. PAINTBALL SAFETY RULES MUST BE FOLLOWED AT ALL TIMES. for updates regarding your PIMP KIT ™...
- Page 3 Paintball Basic Safety Rules Markers with regulators hold pressure even after tank is removed. Shoot marker Read this operator’s manual completely before loading, pressurizing, in safe direction after tank is removed to degas it completely. or operating the EVIL ® Pimp Kit ™...
- Page 4 U.S. Department of Transportation. A cylinder’s rated capacity appears on the cylinder itself. USE N ONLY! DO NOT USE CO ON YOUR PIMP KIT ™ Hydrostatic Testing Date Valve -Cylinder Connection The valve on a cylinder is to remain screwed into the cylinder; Figure 1. Should it loosen, Many cylinders are required by the U.S.
- Page 5 MARKER IS IN USE MUST WEAR PROTECTIVE GOGGLES AND HEADGEAR SPECIFICALLY DESIGNED FOR PAINTBALL. POINTED IN A SAFE DIRECTION WHEN THE BARREL BLOCKING DEVICE IS REMOVED First time users follow instructions carefully until familiar with EVIL ® Pimp Kit ™...
- Page 6 NOTE: The gauge on the front of the marker is the LPR gauge. It should not move when 55 Howard Ave, Des Plaines, Illinois USA; phone 800.579.1633; www.evil-paintball.com adjusting your vertical regulator unless your vertical regulator was less than 150 psi. Your...
- Page 7 Evil Respirator Low Pressure Regulator (LPR) Low Pressure Gauge On/Off Safety Switch Adjustable Double Trigger Indicator LED EVIL Inline Detonator™ Regulator 1. Ball Detent 10160 16. 90º Barb Fitting 56529 On/Off Bottomline 2. 2-56 x .125 56511 17. ASA Gas-Thru Bolt 57709 3.
- Page 8 EVIL Pimp Kit Ram & Reg Diagram ® ™ 62 63 29. Solenoid 56539 59. Pimp Kit ™ Bolt Pin 56515 30. Pimp Trigger Pin 55505 60. Pimp Kit ™ Bolt Pin Spring 56517 31. 10-32 x .250 57747 61. Pimp Kit ™...
- Page 9 Pursuit Marketing, Inc., thanks you for purchasing this high quality EVIL ® Pimp Kit ™ paintball marker. Please read each of the following items and initial that you have read and understood it before operating the EVIL ® Pimp Kit ™ paintball marker: Please fill out entirely this EVIL ®...
- Page 10 62221 10. 4 Ball Detents 10160 11. Barrel Centering O-ring 19/70 U 10265 12. Evil Barrel Condom 61228 ™ Trigger Adjustment Remove Trigger Frame from the marker. You will have to disconnect the Solenoid to completely remove the Trigger Frame.
- Page 11 180º to lock back in place. wires are not covered under the warranty. If the electronic eyes get paint or dirt on them, they will not function properly. DO NOT PUSH BOLT TOO FAR FORWARD IN PIMP KIT ™ OR YOU WILL DAMAGE BALL DETENTS.
- Page 12 57211 12 O-Ring 011/70 Buna 57212 Note: The PIMP KIT’s valve was designed for more cycles of trouble free performance than 13 O-Ring 008/90 Urethane (Poppet O-ring) 40923 most players can afford to play. There should be no reason to remove the valve body from marker...
- Page 13 150 psi. Do not adjust over 170 psi. Greasing the Ram Gauge With the bolt removed, remove the Ram from the back of the Pimp Kit. ™ The easiest way to not damage the Ram O-rings is to unscrew the Ram 5 1/2 full turns and pull it firmly straight out the back without rotating it.
- Page 14 Hold down the trigger and switch on the gun. Keep holding the trigger until the led velocity even after adjusting the Detonator ™ or it is shooting down, see page 19 for changes from Orange to Red (4 seconds). If the led stays unlit then the EVIL ® Pimp Kit ™...
- Page 15 • Paint has gone bad and must be replaced. • Check barrel centering O-ring and make sure it is • Check hopper battery. Marker shoots slow (BPS) firmly seated. • Check Pimp Kit ™ battery. • Buy faster hopper. Paintball doesn’t load •...
- Page 16 PMI, Inc., is not liable for any consequential damages or incidental there will be a minimum labor charge of 20.00 and there may be additional charges damages which may arise from the use or operation of the EVIL ® Pimp Kit ™...
- Page 17 EVIL ® Pimp Kit ™ Paintball Markers manufactured by: Pursuit Marketing, Inc. 55 Howard Ave Des Plaines, Illinois 60018 Phone 1.800.579.1633 847.233.2545 www.evil-paintball.com Please visit www.EVIL-PAINTBALL.com for updates on your EVIL PIMP KIT™ purchase or to download an up-to-date manual...
Need help?
Do you have a question about the Pimp Kit and is the answer not in the manual?
Questions and answers