Operation - Echo CPH-58V Operator's Manual

OPERATION

WARNING
Read and understand entire Operator's Manual for
each optional attachment used on this power head and
follow all warnings and instructions. Failure to follow
all instructions could result in electric shock, fire and/
or serious personal injury.
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING
Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Hearing and/or head
protection may also be required depending on the
type of attachment used and as prescribed in the
attachment's Operator's Manual. Failure to do so could
result in objects being thrown into your eyes and other
possible serious injuries.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
This product will accept Echo 58 V lithium-ion battery packs
only.
For complete charging instructions, refer to the Operator's
Manuals for your ECHO battery pack and charger models.
WARNING
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
8
Installing/Removing Battery Pack
See Figure 4.
To install battery pack:
 Align grooves on battery pack with raised ribs in the tool's
battery port and place the battery pack in the tool.
Make sure the latch on the tool snaps in place and the
battery pack is fully seated and secure in the battery port
before beginning operation. Failure to securely seat the
battery pack could cause the battery pack to fall out,
resulting in serious personal injury.
To remove battery pack:
 Press the battery latch button on the tool and pull the
battery pack out using the handle.
To avoid serious personal injury, always remove the
battery pack and keep hands clear of the trigger lock-
out when carrying or transporting the tool.
Starting/Stopping the Power Head
See Figure 5.
To start:
 Select the desired operating speed (HI or LOW).
 Press and hold the trigger lock-out.
 Depress the switch trigger.
To stop:
 Release the switch trigger to stop the power head.
 Release the trigger lock-out, which will automatically reset
to the locked position.
Operating the Power Head
See Figure 6.
Hold the power head with your right hand on the rear handle
and your left hand on the front handle. Keep a firm grip with
both hands while in operation. Power head should be held at
a comfortable position with the rear handle about hip height.
If debris becomes wrapped around the attachment, RELEASE
THE SWITCH TRIGGER, remove the battery pack, and
remove the debris.
English
WARNING
WARNING