Avermedia EzRecorder 130 Manual
Hide thumbs Also See for EzRecorder 130:

Advertisement

Locate the AverMedia "EzRecorder 130" ("ER130") to the right of the TV.
Turn on "VIDEO SYSTEM" using to white switch on the desk.
Light on the "ER130" should show ORANGE.
Insert the "V" USB flash drive into front of the recorder.
Press the "REC" button on the "ER130" to turn on the unit.
Light on the "ER130" should show blinking GREEN during power on (about 30 seconds).
Light on the "ER130" should show GREEN when ready to record.
At start of Church service or event:
Press the "REC" button on the top of the "ER130" recorder.
Light on the "ER130" should turn to slow blinking RED while recording.
At End of Service:
To STOP recording, press the "REC" button on the top of the "ER130" recorder.
Light on the "ER130" recorder should change to rapid blinking RED while video recording
finishes.
Light on the "ER130" should change to GREEN when the recording is done.
To Release/"EJECT" the
controller.
Light on the "ER130" recorder will blink GREEN once.
To turn off the "ER130" recorder:
Press the RED button on the remote control. WAIT.
-or-
Press and Hold
than 4 seconds
Light on the "ER130" should change to blinking GREEN while "power off" is in progress.
With the flash drive installed, it takes about 15 seconds for full off.
(With no flash drive, it take about 7 seconds for full off.)
Wait for light to turn solid ORANGE.
"V"
Remove the
"V"
Return the
USB flash drive to the church office.
TTForce\2018SoundSystemUpgrade\2018ChurchHDMI\20190122HDMIOperatingProcedure.opt
Recording video to "V" USB flash drive
"V"
USB flash drive, press the "F1" button on the "ER130" Remote
the "REC" button on the top of the "ER130" recorder
and WAIT.
USB flash drive from the "ER130" recorder.
Page 1 of 4
for more
5. Feb. 2019

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EzRecorder 130 and is the answer not in the manual?

Questions and answers

Summary of Contents for Avermedia EzRecorder 130

  • Page 1 Recording video to “V” USB flash drive Locate the AverMedia “EzRecorder 130” (“ER130”) to the right of the TV. Turn on “VIDEO SYSTEM” using to white switch on the desk. Light on the “ER130” should show ORANGE. Insert the “V” USB flash drive into front of the recorder.
  • Page 2 This document presents operating procedures for making video recordings. Turning on the Video sub-system: Locate the AverMedia “EzRecorder 130” (“ER130”) to the right of the TV. Turn on “VIDEO SYSTEM” using to white switch on the desk. The system takes about fifteen seconds to power up. Please be patient.
  • Page 3 Insert the “V” USB flash drive into front of the “ER130” recorder. Press the “REC” button on the “ER130” to turn on the unit. Light on the “ER130” should show blinking GREEN during power on Light on the “ER130” should show GREEN when ready to record. You should see.
  • Page 4 The monitor will display “HDMI” and then add “720p@60 Hz” on the bottom yellow line. It might perform a 'display and blank' cycle a couple of times. This is normal during initialization. The AverMedia EzRecorder 130 HDMI signal output is connected to the display.

This manual is also suitable for:

Er130

Table of Contents