Page 1
DI (RODI) filtration - It is also possible to have the SMARTANK® tank system on a skid mount, installed into a trailer system or installed into a vehicle. It is therefore important for the operator to read all instructions provided by the manufacturer.
Pay particular attention to general safety instructions. Electrical Specifications & Safety Safety Precautions Please keep this booklet in a safe place near your SMARTANK® tank system for future consultation. Personal Safety System Safety Your SMARTANK® tank system is constructed according to current safety standard and regulations.
SMARTANK ® Technical Specifications Parts and Accessories Technical Specifications Specification Data The SMARTANK® tank system will include the following parts: PRODUCT CODE SMT400 SMT650 SMT1000 No Filtration Country of Origin United Kingdom United Kingdom United Kingdom Maximum Height 438mm 438mm...
• Do not use the SMARTANK® with telescopic poles in the vicinity of power lines, junction Before connecting the equipment, check that the specification given on the rating plate boxes, power sockets –...
Personal Safety System Safety Stay alert, watch what you are doing and use common sense when operating the SMARTANK® tank The SMARTANK® tank system is manufactured with the safety of the operator in mind, including system. Do not use the filtration system while you are tired or under the influence of alcohol, drugs some key features such as;...
Unpacking of the SMARTANK® system Your SMARTANK® system has been carefully manufactured, checked through QC and packaged as a kit. If your SMARTANK® is installed in a vehicle or trailer, please move to STORAGE OF Important SMARTANK® System. The unit must be protected from freezing.
SMARTANK ® Stay alert, watch what you are doing and use common sense when operating the SMARTANK® tank system. Do not use the filtration system while you are tired or under the influence of alcohol, drugs or medication. A moment of inattention while operating the filtration trolley may result in serious personal injury.
Page 9
Plug in Charger iv. A flashing light shows poor connection. If your SMARTANK® is in a trailer system or on a skid mount plate, it is likely your SMARTANK® will need to be manually charged with a mains charger. Plug charger into an electrical socket The battery charging cycle is approx.
Page 10
Reverse Osmosis filter is fully open (turn anti-clockwise). No Filtration When using the SMARTANK® with no filtration, you have the option of filling through the water inlet port, or opening the tank lid and fast filling with a transfer nozzle. Important Your SMARTANK®...
Page 11
Important achieved. The average flow rate is If your SMARTANK® system has an optional extra booster pump, you can switch on to boost usually set between 40-50 on the the fill pressure to reach 100psi / 6bar. This will reduce the filling time and have a longer life STREAMLINE®...
The water supply can sometimes be interrupted for short lengths of time i.e. when the operator moves from window to window. However if the SMARTANK® system is interrupted for long periods of time, it is best to switch off the pump to save overheating and/or over pressurising, and iii.
Re-charge your battery as soon as possible. If you have a split charge relay fitted to your Check if membrane has the plug installed – if so, replace membrane SMARTANK® system, start your vehicle engine which will then start the charging process. Contact service centre •...
To adjust dead-end detection, press and hold at the same time. Wait for ‘Cal’ to display and flash on Care and maintenance of your SMARTANK® system will ensure it is well looked after and running the screen. smoothly every time. hold It is recommended to run a weekly, monthly and quarterly examination on the SMARTANK®...
This system relies on a series of filters to produce pure 000ppm water. To ensure that your The prefilter set are the first initial filter set the feed SMARTANK® filters operate efficiently, the filters will need to be changed in accord with water will pass through.
Page 16
1) Ensure the SMARTANK® is switched off and no 6) Reassemble the head and riser, and clamp the water filling into the tank filter back into position before attaching...
All STREAMLINE® products carry a full one year’s warranty, according to the manufacturers’ standard terms and conditions of sale. The SMARTANK® system is classified as special waste. It must be taken apart and divided into uniform sections which should be disposed of according to current legislation.
STREAMLINE® will pay for the cost of the repaired or replacement part. This warranty excludes the following conditions and circumstances which are at the discretion of STREAMLINE®: W: www.streamline.systems E: sales@streamline.systems T: +44 (0)1626 830 830 W: www.streamline.systems E: sales@streamline.systems T: +44 (0)1626 830 830...
Page 19
Hamilton House, 8 Fairfax Road, Heathfield Industrial Estate, Newton Abbot Devon, TQ12 6UD United Kingdom Telephone: +44 (0) 1626 830 830 Email: sales@streamline.systems INSTR-SMT Visit www.streamline.systems...
Need help?
Do you have a question about the SMARTANK and is the answer not in the manual?
Questions and answers