Rangemaster RWC 3018 BL User's Manual & Installation Instructions page 15

Stability fixing
Your appliance is provided with a stability bracket.
The top hinge has a hole, into which a low profile
countersunk wood screw should be fitted (Fig. 4.4), to secure
your appliance to the underside of a worktop (Fig. 4.5). This is
the security bracket.
Before using for the first time
Clean the inside of the cabinet (see "Care & Maintenance"
on page 7).
Wait for 1 to 1.5 hours after placing the appliance in its final
position to allow the refrigerant to settle before connecting it
to the mains power supply.
Levelling feet
The appliance must be installed level to work properly.
If the unit is not level, the doors and magnetic seal
alignments, will not function correctly.
To level the unit, adjust one or both levelling feet, at the base
of the unit. Use a spirit level on a fixed surface to check your
product is level.
Adjustable feet
The appliance comes with height adjustment feet which
allow the appliance to be installed under bench and ensures
the appliance is stable and level.
Rotate the bottom feet anti-clockwise to raise the height up
to 880 mm. Or clockwise to lower the height to 820 mm
(Fig. 4.6).
Climate Class
Your wine cabinet is Climate Class N.
Each item has a climate class (shown on the rating label)
where it indicates the temperature range of the appliance.
The appliance may not work properly if it is left for a long
period at a temperature outside the specified range
(Table 4.1).
Details on how to set the internal temperature can be found
on page 5 of this manual.
Fitting an external plinth (ventilation)
You may wish to fit an external plinth across the front of
your appliance. This is allowed, however, you must provide
a suitable vent in the external plinth. Failure to provide
adequate ventilation will impair the function of your
appliance.
See Table 4.2 as a guide.
An example of an external vent is shown in Fig. 4.7.
Worktop
Countersunk screw
Normal height
x 4 feet
Climate Class
SN
N
ST
T
Model
RWC 3018 BL/
RWC 3018 SS/
RDZ 6046 BL/
RDZ 6046 SS/
Free area = X x Y x no. of slots (mm²)
11
After adjustment
Amb. T. (ºC) Amb. T. (ºF)
10 - 32
16 - 32
16 - 38
16 - 43
Table 4.1
Free Area (mm²)
6000
14000
Table 4.2
x
Y
Fig. 4.4
Screw hole
Fig. 4.5
Hinge
Fig. 4.6
x 4 feet
50 - 90
51 - 90
61 - 100
61 - 110
Fig. 4.7