Advertisement
Quick Links
COMPLETE GRINDER
PACKAGE SYSTEM
TH PRO SYSTEM
INSTALLATION AND SERVICE MANUAL
NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible
party who maintains the system.
Item # E-03-515 | Part # 5625-515-1 | © 2012 Pentair Pump Group, Inc. | 11/05/12
Advertisement
Related Manuals for Pentair HYDROMATIC
Summary of Contents for Pentair HYDROMATIC
- Page 1 NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible party who maintains the system. Item # E-03-515 | Part # 5625-515-1 | © 2012 Pentair Pump Group, Inc. | 11/05/12...
-
Page 2: General Information
personnel capable using General reasonable engineering principles Risk of fire or explosion. Do for the installation and operation Information not smoke or use open flames of the system. in or around this system. This Thank you for purchasing your system is not intended for use in Pressure Sewer Basin... - Page 3 Claims for this type proper size hole saw if necessary. tie-down kits are available from of damage cannot be processed Hydromatic. If concrete pad is by Hydromatic. ** 6" pipe size requires use of a not used, the aggregate must be fiberglass basin.
- Page 4 A. Gravel – clean and free Step 2 Backfill flowing with particle size not At least a 4 inch wide band of less than 1/8" or more than Instructions compacted aggregate must be 3/4" in diameter. Use this placed in successive layers (6" description when ordering or lifts) around the entire periphery authority...
- Page 5 Systems Description: Step 3 Internal Basin Factory built basin systems are Attach lifting chain, cable or rope Installation available in 24" diameter basins as supplied to the lifting eye bolts. with 48" through 96" depths in Instructions one-foot increments. In the system, the pump and piping assembly is Risk of electrical shock or raised and lowered in the basin...
- Page 6 Disconnect all power sources through the basin wall. If using a processed by Hydromatic. prior to handling or servicing fiberglass basin, clean the edges pump or grinding mechanism.
-
Page 7: Pump Troubleshooting
Step 3 1. Cutters may be clogged. Step 6 Amperage higher than With power off, turn radial cutter Float adjustment for simplex nameplate may indicate this with a screwdriver to be sure systems: problem. it rotates freely. If necessary Adjust floats so that the water to adjust, refer to pump service 2. - Page 8 cord end – nothing should Circuit breaker trips when NOTE: Use twisted shielded pump tries to start. happen. While keeping the Off cable for seal failure cable runs float tilted, tilt the On float in 1. Short circuit in pump motor. in excess of 100 feet.
-
Page 9: Ordering Replacement Parts
Fiberglass Simplex Parts List ORDERING REPLACEMENT PARTS: Product improvements are made from time to time. The latest part design will be fur nished as long as it is in ter change able with the old part.When ordering re place ment parts, always furnish the fol low ing information: (1) pump serial num ber, (2) pump model and size, (3) part description, (4) part number, (5) quan ti ty required, and (6) shipping instructions. - Page 10 THIS PAGE INTENTIONALLY LEFT BLANK...
- Page 11 THIS PAGE INTENTIONALLY LEFT BLANK...
-
Page 12: Standard Limited Warranty
Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. Under no circumstance will Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Hydromatic service facility.