Power Source; Battery Removal And Installation - VTech PAW Patrol: The Movie: Learning Watch Parents' Manual

de votre enfant ne soit ni trop serré, ni trop lâche. Si vous observez
des rougeurs, gonflements ou autre irritation, veuillez consulter un
médecin avant de remettre la montre.
INSTRUCTIONS

Power Source

The PAW Patrol: The Movie: Learning Watch operates using one
CR2450 battery. The CR2450 battery included with the product is for
demo purposes only.

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover located on the back
of the unit, use a screwdriver to loosen the
screw and then open the battery cover.
3. Remove the old battery by pulling up on one
end of the battery.
4. Install one new CR2450 battery following the
diagram inside the battery cover.
5. Replace the battery cover and tighten the
screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
5 5
5