Ats125X Programming Menus; Initialise The Database - GE ATS125 Series Installation Manual

2. Enter the number of the remote device you want to program.
Remote DGP Setup
DGP No.:
The DGP number is the same as the DGP address.
The following is briefly displayed:
Connecting...
Enter to Abort
You have now accessed the ATS125x Programming menu for the ATS125x that
you have selected. The display shows the 4-door programming menu display:
"#" –Move On
Menu:
See the "ATS125x programming menus" below for information on available options
and how to set them.

ATS125x programming menus

No. Menu
1. DGP Options
2. Door Options
3. Initialise Database
4. Display Card
5. Door Groups
6. Reserved
7. System Options
8. Program Macro Logic
9. Version Number
10. To Local Devices

Initialise the database

Initialise the 4-door DGP on initial power-up only. This is done via the door data menu
option 3, Initialise database.
Caution: All programming and settings will be reset to factory defaults. Factory
defaults are listed in the programming guide.
14
"*" Move back
Description
Global options valid for all doors of the selected 4-door DGP.
Options valid for each individual door on the ATS125x.
Allows initialisation of door database. Resets all data in the DGP to
default.
Displays card details on LCD for the last card that is badged.
Allows door group details to be viewed.
Allows ATS125x outputs to be activated to indicate system faults on
the ATS125x.
Enables outputs and internal events to be generated by logic
functions using ATS125x events.
ATS125x firmware and CPLD version number.
Enables you to access the remote devices on the local databus.
ATS125x 4-Door DGP Installation Manual