TECNICOMAR MINIMAR PLUS Instructions For The Installation, Use And Maintenance page 17

When the system is OFF, by holding this key for 4 seconds is possible to start only the low pressure
pump (A). This function is useful to backwash the Sand Filter (if the model installed is with manual
F1
valves) or to circulate the membranes cleaning chemicals.
F2
When the system is OFF, this key can start the automatic membrane flushing system - if installed - (push
for 4 seconds). When the " lamp change" warning appears, this key allows to cancel it (push for 4 sec.).
RESET
When a failure occurs the RESET key allows to switch-off the acoustic alarm and to reset the control
box.
Unsafe Water
The unit is producing unsafe water that is being discharged outboard.
High Pressure
The unit stops for high working pressure. Push RESET to re-start it. Check section 8 "Troubleshooting" for possible
causes.
Low Pressure
The unit stops for low working pressure. Push RESET to re-start it. Check section 8 "Troubleshooting" for possible
causes.
Overload
The unit stops for overload. Push RESET to re-start it. Check section 8 "Troubleshooting" for possible causes.
Instructions for the installation, use and maintenance of Tecnicomar watermaker
WARNINGS ON THE DISPLAY
VISUAL and SOUND ALARMS
4-17