Maintenance - Blomberg MBS 3101 Instruction Manuals

FRYER:
To set the cooking temperature, turn the knob clockwise, up to a maximum setting of
200°C.
When the heating element comes on, two lights, one green and one red, light up. The red
light goes out when the selected temperature is reached.
It is normal for some types of lamp to show a little light even when the plates are not
working.
ADVICE AND WARNINGS:
Put the frying oil in the container provided before switching on the heating element.
After cooking, wait for the oil to cool before emptying the container.
After cooking, turn knobs back to the "0" setting.
If the regulator thermostat fails, a thermostat with manual reset will be activated; this must be reactivated by a
skilled engineer.

MAINTENANCE

ALL ADJUSTMENT, SERVICING ETC. PROCEDURES MUST BE CARRIED
OUT WITH THE APPLIANCE DISCONNECTED FROM THE ELECTRICITY
SUPPLY.
To extend the appliance working life, it must be cleaned regularly, following the
instructions below:
- Electrical element:
For a longer working life, heat the element for a few moments to burn off any residues left
on it during the manufacturing process.
- Control panel:
To keep the control panel looking its best, do not use abrasive products or dry, dirty
cloths. For easier cleaning, you may remove the knobs by pulling them up (do not apply
leverage on the control panel). If the knob is stiff, apply leverage with a cloth underneath
it, and remove it carefully.
- Cast Iron parts:
Simply clean with soap and water with the appliance cold, and dry with a clean, dry cloth.
Do not clean when hot, as this may alter the colour of the cast iron.
- Stainless Steel Parts:
Use commercially available products.
4