Table of Contents
Advertisement
The floor must have a sufficient load-
bearing capacity! If, for example, you
are stacking a washer and the dryer,
this combination can – when loaded –
reach a total weight of 160 kg.
Important:
• Place appliance on an even an level
floor only.
• Do not stand appliance on the power
cable.
• Keep at least 1 cm distance to walls or
other furniture.
Built-under installation
This appliance can be installed under a
worktop.
• For this a special top cover is required
(stock no. AP 2000), available at the
customer service or specialised trade.
Only authorised specialists are permit-
ted to carry out a built-under installa-
tion. Risk of electric shock!
Washer/dryer combination
This appliance can be put on top of any of
our washing machines.
• A special stacking kit is required (stock
no. MBS2000), available at the cus-
tomer service or specialised trade.
Levelling
• Adjust feet until the appliance is level
and does not rock. Checking with a
spirit level is recommended.
Important:
• Adjust by the feet only, do not use
wooden wedges or similar. Never re-
move the feet!
Changing hinge position
If you wish to open the door to the other
side, you can have the hinge position
changed from left hand to right hand or
vice versa by our customer service.
Drain hose connection
The water arising from drying ("con-
densed water") is normally collected in the
condensed water container, which needs
to be emptied after every drying cycle.
• The condensed water can also be
drained permanently by means of the
drain hose supplied into a siphon trap
or any other drain.
In that case the condensed water con-
tainer needs no longer to be drained –
nevertheless the >Reservoir full
indicator will light at the end of each
drying cycle.
Important:
• In order for the water to run off ob-
serve the maximum hose length and
highest point above the floor (see
"Technical Specifications")!
• Ensure that there are no sharp bends
in the hose!
Here's how to proceed:
1. At the water drain connector, pull the
hose up from inside the appliance by
hand. Do not use pliers!
2. Push the drain hose firmly on the wa-
ter drain connector.
3. Run the drain hose to the waste outlet
of a washbasin and connect it.
4. If the drain hose is hung to the edge of
a washbasin or bathtub, secure it
against slipping off.
4
<
Hide quick links:
Advertisement
Table of Contents
