Vent Exhaust Air Out Of Doors; Built-Under Installation - Blomberg TAF 1330 Instruction Manual

Electronic vented dryer
Hide thumbs Also See for TAF 1330:
Table of Contents

Advertisement

Operate the appliance only in well
ventilated, low dust rooms. Do not
block or cover the appliance's vent
slots.
The floor must have a sufficient load-
bearing capacity! If, for example, you
are stacking a washer and the dryer,
this combination can – when loaded –
reach a total weight of 160 kg.
Important:
• Place appliance on an even and level
floor only.
• Do not stand appliance on the power
cable.
• Keep at least 1 cm distance to walls or
other furniture.

Vent exhaust air out of doors!

The appliance has three exhaust outlets, at
the rear and the side panels; the side out-
lets are closed by removable covers.
The exhaust air should not be simply
led into the room, since the high hu-
midity may cause longterm damage
to walls and furniture.
• Connect the vent tube with the 90°
offset connector or the straight one
to one of the exhaust air outlets.
• The two other outlets not used must
be closed by the covers.
The vent tube
– can be run through an open window
to the outside;
– can be connected to a wall-mount
vent.
The exhaust air must not be led into
flues or chimneys of fireplaces. Check
with your chimney sweeper or heating
engineer.
• Instead of the vent tube vent pipes
can be used. The diameter should be
at least 10 cm.
• Tube or pipe, respectively, should be
routed in the straightest and most di-
rect pathoutdoors, i.e. with the fewest
number of elbows and turns, as these
hamper airflow.
• The maximum length of a straight
routed tube/pipe is given in the chart
below.
• For each elbow and other obstructions
the respective value shown is to be de-
ducted from the maximum length.
Max. length
less...
1 elbow 45°
1 elbow 90°
1 elbow 90° short turn
1 wall-mount vent*
* with automatic louvers

Built-under installation

This appliance can be installed under a
worktop.
• For this a special top cover is required
(stock no. AP 2000), available at the
customer service or specialised trade.
4
Hose
Pipe
8.0 m
10.0 m
– 1.0 m
– 0.3 m
– 1.8 m
– 0.6 m
– 2.7 m
– 2.0 m
– 2.0 m

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Taf 1330 a

Table of Contents